User manual AEG-ELECTROLUX FAV5040 I B

[. . . ] With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 5 5 Prior to using for the first time . Adjusting the height of the upper basket. [. . . ] 4) During the final rinse, the temperature is increased to 68° for 10 minutes to disinfect e. g. 5) Test programme for Test Institutes. 20 14 - 16 23 - 25 9 13 - 25 Water (litres) Dishwashing cycle Suitable for: Type of soiling Main wash Pre-wash Final rinse Drying Starting a dishwashing cycle 1. Check that the spray arms can turn freely. One or two lights will flash in the programme progress display. The selected cycle will begin after approximately 3 seconds. Interrupting or aborting a dishwashing cycle Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 2 and 3 and keep them pressed. The programme display for the current cycle will flash for several seconds and then go out. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. Place the coarse and fine filters in the micro-filter and press together. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. 23 1 What to do if. . . Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. If the fault is displayed again or if other faults are displayed, please contact the Customer Care Department and inform them of the fault display. Malfunction Possible cause The tap is blocked or furred with lime-scale. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in rhythm 1 short light signal with approx. 3 second pause in-between: There is no water entering the dishwasher. Turn the tap on. The filter (where present) in Clean the filter in the the threaded hose fitting on threaded hose fitting. Press the button for the dishwashing cycle that has started; then abort the dishwashing cycle (see section: Starting a dishwashing cycle); clean filters (see section: Cleaning the filters). [. . . ] The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. The guarantee does not apply to defects due to transport which have occurred outside of our responsibility. [. . . ]