User manual AEG-ELECTROLUX FAV5040 I M

[. . . ] Useful tips and hints Environmental information 3 Your dishwasher is fitted with the new "PULSE WASH" dishwashing system. With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 6 6 Prior to Using for the First Time. [. . . ] During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to the size of the load, degree of soiling, etc. 3 Interrupting or Cancelling a dishwashing cycle Interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 1 and 2 and keep them pressed. The programme display for the current cycle will flash for several seconds and then go out. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 22 Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Then rinse out the spray arm using a strong jet of water. Do not damage the jet opening. 3 Upper basket spray arm 1. To remove upper basket spray arm, tilt it down hard. Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 26 What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: ­ Fault codeÅ 10 (Problems with water inlet), ­ Fault codeÅ 20 (Problems with water drainage), please have a look at the following table. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. ­ Switch the appliance off and on again. If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code. Malfunction Possible cause Water tap is blocked with limescale or faulty. [. . . ] · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. [. . . ]