User manual AEG-ELECTROLUX FAV5040 I W

[. . . ] With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 5 5 Prior to using for the first time . Adjusting the height of the upper basket. [. . . ] The selected cycle will begin after approximately 3 seconds. During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to the size of the load, degree of soiling, etc. 3 Interrupting or aborting a dishwashing cycle Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 1 and 2 and keep them pressed. The programme display for the current cycle will flash for several seconds and then go out. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 20 Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. ­ Switch the appliance off and on again. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. 23 Malfunction Possible cause Water tap is blocked with limescale or faulty. The tap is turned off. Remedy Check the water tap and have it repaired if necessary. Turn the tap on. The cycle indicator for the selected dishwashing cycle is flashing: fault code Å 10 is displayed in the multi-display: (Problems with water inlet) The filter (where present) in Clean the filter in the the threaded hose fitting threaded hose fitting. Press the button for the commenced dishwashing cycle; then abort the dishwashing cycle (see section: Starting a dishwashing cycle); clean filters (see section: Cleaning the filters). Filters in the base of the dishwasher compartment are blocked. Water inlet hose Check the position of the has not been correctly posihose. The cycle indicator for the selected dishwashing cycle is flashing, fault code Å 20 is displayed in the multi-display. (Problems with water drainage) Fault code Å 30 is displayed in the multi-display. Clean out sink outlet. Water drain hose Check the position of the has not been correctly posihose. tioned. The anti-flood system has been triggered. [. . . ] Box 1 35 Muscat Tel. : 703743 Egypt Middle East Commercial Center P. O. Box 19 Kairo-Heliopolis Tel. : 29917/31634 Australia The Andi-Co Group 1 Stamford Road Oakleigh VIC 3166 Tel. : (03) 9569 1255 Fax: (03) 9569 1450 www. andico. com. au Bahrain/Arabian Gulf A. A. Box 9 32 Bahrain Tel. : 261060 Bulgaria Electrolux Bulgaria E. O. O. D. 2 980 5276 Cyprus Hadjikyrlakos & Sons Ltd. [. . . ]