User manual AEG-ELECTROLUX FAV55750I-M

[. . . ] ÖKO-FAVORIT 55750 Dishwasher Instructions for use Dear Customer Please read these operating instructions carefully. Please make sure you read the safety instructions on the first pages of these operating instructions!Keep the operating instructions for future reference. With the warning triangle and/or by means of key words (Caution!, Important!), informa- tion is emphasized which is important for your safety or the correct functioning of the ap- pliance. [. . . ] - By repeatedly pressing the button, the delay time can be programmed in hours, and will be displayed in the display field. Display: Hours and a small "h". 16 A washing program can be selected first, and then the pre-selected start time can be pro- grammed, or vice versa. If a pre-selected start time is programmed without a washing program, the programmed time goes out after 5 seconds. After selecting a program, the selection of the start delay must take place within 5 seconds. An activated pre-selected start time will be indicated in the display field by a blinking dot. After the pre-selected start time has expired, the machine starts up the selected program automati- cally. Correcting or Deleting the Program Selection / Pre-se- lected Start Time Using the Stop button, a running program or the pre- selected start time can be interrupted or cancelled. Interruption: - Briefly activating the Stop button causes an inter- ruption of all programs, and the Stop control lamp blinks. - Activating the Stop button again makes the pro- gramming active once again. Cancelling: - Holding down the Stop button longer than 2 se- conds deletes the program and the pre-selected start time, and any water present will be pumped out. The Program End symbol in the display lights up as soon as all the water has been pumped out. ECO button The wash temperature is reduced using the ECO button, as a result less energy is consumed during heating up. The economy button can be selected for all wash pro- grams. The ECO button should be used in particular when using low-alkali compact cleaners with enzymes. The enzymes produce their full dirt-releasing effect in a temperature range between 40 and 50 °C. Using the Half Load button, energy is saved if the dish- washer is only half full. Nevertheless optimal washing results are achieved (see Program Chart). In the case of the simultaneous selection of ECO and Half Load, the Half Load program is run. Half load Mains switch Economy 17 Intermediate Rinse Program Chart Gentle Light to normally soiled crockery 45°C 40°C 40°C 65°C 60°C 60°C 59 min. 45 min. + ECO Lightly soiled crockery Lightly soiled crockery with half load + Normal Heavily-soiled crockery 50°C 68°C 70 min. 2. 5 h + ECO The most economical programme for stubborn dirt. Using this programme, AAA performance in accordance with the EN 50242 "Energy Label" is achieved *) Normally soiled crockery with half load 50°C 68°C Intensive Very heavily-soiled crockery + ECO Heavily to very heavily-soiled crockery Heavily to very heavily-soiled crockery with half load + Quick Very light to lightly soiled crockery + ECO very lightly soiled crockery very lightly soiled crockery with half load + Pre-rinse Wash off cold The programme times and temperatures are intended as a guide only. The actual programme times will de- pend an incoming water temperature an pressure *) A = Best energy efficiency A = Best cleaning result A = Best drying result Programme with significantly extended drying For the test washes in accordance with the test standard EN 50 242 (see page 31) extremely stubborn soiling is used that only rarely occurs in day to day use. We therefore recommend the selection of a program appropriate for the level of soiling in accordance with this chart. Dried-on residues mostly requires a powerful program. 18 ÇÇÇÇÇÇÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇÇÇÇÇÇ ÇÇÇÇÇÇÇÇÇÇÇÇ + 50°C 65°C 64 min. 47°C 68°C 73°C 86 min. [. . . ] Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. A cut off plug inserted into a 13amp socket is a serious safety (shock) hazard. Ensure that the cut of plug is disposed of sa- fely. Permanent connection In the case of permanent connection it is necessary that you install a double pole switch between the ap- pliance and the electricity supply (mains), with a mini- mum gap of 3mm between the switch contacts and a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. AEG 28 153 0409 25 / 09. 99 Assembly Instructions for the Side Rail Assembly Detail A SL L Kit Components: right neighbouring 1 off Side rail, SL R 1 off 4 off 4 off 4 off Side rail, left Spacer 4 mm Spacer 3mm Spax screw 4. 0 x 20 galvanised SL L DS 1 DS 2 SCHR Detail B DS 1 600 DS 2 edge SL L SCHR 100 19 21 A+B 16 759 19 510min. [. . . ]