User manual AEG-ELECTROLUX FAV6050-W ML

[. . . ] 39 Extractor version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Filter Version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Control Panel - EFP 6430 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The control switches are located on the units front panel: A B E F C DG H I A - Main switch, hood off. B - Start and choice of motor speed 1-2-3-12. . . . . . . . . D - Indicates speed 2 and saturation of the grease filter (LED) E - Indicates speed 3 and saturation of the charcoal filter (LED) (flashing LED) F - Indicates Intensive speed (LED). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. H - Light OFF I - Light ON The extractor part (visor) of the hood is used to switch the fan on and off when the appliance is switched on (Motor). When the visor of the appliance is withdrawn, the fan automatically switches on. If the visor is pushed in without operating the switches, the fan is switched off. The lighting can be separately switched on and off with the slide switch. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (in the case of recirculation version with charcoal filter). 942 120 399 Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. After approximately three years of use, the charcoal filter should be replaced with a new, as the odour reduction capacity will be reduced. Fig. 4 CLOSED CLOSED OPEN OPEN Changing the light bulb(s) EFP 6430 Disconnect the unit from the mains power supply. Replace the old light bulb with a new light bulb of the same kind. If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service. EFP 6410 Fig. 5 43 Something Not Working If your appliance fails to work properly please carry out the following checks. [. . . ] Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. Fixed connection of the appliance must only be carried out by an authorised electrician. Electrical connection for UK only Safety warnings for the electrician Connect the hood to the mains supply via a double pole switch which has 3 mm minimum separation between the contacts. The switch must be accessible at all times. [. . . ]