User manual AEG-ELECTROLUX FAV6050I-D

[. . . ] With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 5 5 Prior to using for the first time . Adjusting the height of the upper basket. [. . . ] The cycle will recommence after turning the dishwasher back on again. 3 21 Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi-display. The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Switching off the dishwasher Do not switch off the dishwasher until the multi-display indicates "0" for the remaining cycle time. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. Therefore leave the dishes to cool for about 15 minutes before removing them. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. ­ Switch the appliance off and on again. 25 If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. Malfunction Possible cause Water tap is blocked with limescale or faulty. The cycle indicator for the selected dishwashing cycle is flashing: the control indicator WATER is lit, fault code Å 10 is displayed in the multi-display (Problems with water inlet). Remedy Check the water tap and have it repaired if necessary. Turn the tap on. The filter (where present) in Clean the filter in the the threaded hose fitting threaded hose fitting. Press the button for the dishwashing cycle that has started; then abort the dishwashing cycle (see section: Starting a dishwashing cycle); clean filters (see section: Cleaning the filters). Filters in the base of the washing compartment are blocked. Water inflow hose Check the position of the has not been correctly posihose. The cycle indicator for the selected dishwashing cycle is flashing, fault code Å 2 0 is displayed in the multi-display (there is water in the dishwasher's internal dispenser). Fault code Å 30 is displayed in the multi-display. Clean out sink outlet. Water drain hose Check the position of the has not been correctly posihose. [. . . ] Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. AEG Showroom Shariati, Balatar as Safar Teheran / Iran Phone No. Service: 021 / 312 27 67 / 8 Poland Electrolux Poland Sp. Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. [. . . ]