User manual AEG-ELECTROLUX FAV6081-W

[. . . ] ÖKO_FAVORIT 6081 Dishwasher User Instructions Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions!Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. 1 0 The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. [. . . ] Variations are therefore possible in practice. 6) When the hardness setting is electronically adjusted to 10, the length of the dishwashing cycle may be slightly longer. 26 Operating Instructions Starting a dishwashing cycle 0 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. The LED in the ON/OFF button will become illuminated. Press the relevant button for the cycle required (see "Cycle Table"). The cycle display will become illuminated. The remaining time for the cycle will be shown in the multi-display. The selected cycle will begin after approximately 3 seconds. 3 3 During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to amount of dishes, degree of soiling, etc. If an error message is displayed in the multi-display after the cycle has begun, please read the section "What to do if . . . ". Changing/interrupting/aborting a dishwashing cycle 3 Only change or interrupt a dishwashing cycle that is in progress if it is absolutely necessary. After the appliance has been closed again, the air that has entered will be heated significantly and expand. As a result, water may collect in the base of the appliance and trigger the antiflood system. Changing a dishwashing cycle If you would like to change the dishwashing cycle in the first 3 seconds after having selected a cycle, briefly press the button for the new dishwashing cycle. If you would like to change the dishwashing cycle after this time, proceed as follows: 0 1. Press the button for the new dishwashing cycle and hold it down. The indicator for the dishwashing cycle that is currently running will flash. After several seconds only the indicator for the new dishwashing cycle will be flashing. The newly selected dishwashing cycle will begin. 3 27 Operating Instructions Interrupting the dishwashing cycle by opening the dishwasher door Hot steam may escape when the door is opened. The dishwashing cycle will continue. 1 Aborting the dishwashing cycle (RESET) 0 1. Press the function buttons 1 and 2 simultaneously and keep them pressed. The cycle display for the current cycle will flash for several seconds and then cease to be illuminated. The dishwashing cycle has been aborted. 3 Turning off the dishwasher will only interrupt a selected dishwashing cycle, not abort it. The dishwashing cycle will recommence after turning the dishwasher back on again. Setting or changing the start delay Using the start delay timer you can adjust when within the next 19 hours the dishwashing cycle is to begin. [. . . ] 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Japan Electrolux Japan Ltd. Domestic Appliances Department Maruzen Showa Warehouse Building Tookai 4-5-12, Ota-ku 143-006 Tokyo Tel. : 0120-13-7117 Fax: 03-3790-5257 Thailand OLYMPIA Thai Ltd. 44 Ratchadapisek Road 10320 Bangkok Tel. : 2 513 6111 Fax: 2 513 2574 Hungary Electrolux Lehel KFT (AEG Div) Erzsebet'Kiralyne Utja 87 1142 Budapest Tel. : 00361/251 84 44 Slovakia Rep. Seberiniho 1 821 03 Bratislava Tel. : 02 4333 4322, 4355 Fax: 02 4333 6976 USA ANDI Co. [. . . ]