User manual AEG-ELECTROLUX FAV625

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. 4 4 5 5 Prior to Using for the First Time. Selecting the dishwashing cycle (Cycle Table) . 13 13 16 18 19 21 21 22 Care and cleaning . [. . . ] 30 minute programme). 20 Starting a Dishwashing Cycle 1. Check that the spray arms can turn freely. The selected cycle will begin after approximately 3 seconds. Interrupting or Cancelling a dishwashing cycle Interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 2 and 3 and hold them down. The LED indicators of all the programme buttons that can be selected will illuminate. If you want to start a new wash programme, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. Press the Delay Timer button repeatedly until the indicator next to the number of hours for which the start of the dishwashing cycle is to be delayed lights up, e. 6h, if the cycle is to start in 6 hours. The LED indicator for the programme selected and the indicator next to the number of hours will light up. Under no circumstances may the dishwasher be used without its filters. Cleaning the spray arm jets Regularly check the jets in the spray arms for blockages. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Then rinse out the spray arm using a strong jet of water. Do not damage the jet opening. 3 Upper basket spray arm 1. To remove upper basket spray arm, tilt it down hard. Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 25 What to do if. . . Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. In the case of other fault messages: ­ Cancel the dishwashing cycle. ­ Switch the appliance off and on again. [. . . ] · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. [. . . ]