User manual AEG-ELECTROLUX FAV675A ITA

[. . . ] It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step for step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. Tips and instructions for the economical and environmentally conscious use of the appliance are marked with a clover leaf. [. . . ] 1. 75 ­ 1. 95 kWh 19 - 21 litres 85 - 95 min. < 0. 1 kWh 4 litres 1) During BIO programmes the water is briefly heated to more than 50 °C so that the active oxygen becomes effective. 2) The various stages in the wash programme have different sounds because the dishes are washed more intensely for short periods during certain stages of the wash programme to improve cleaning. 3) The consumption figures were recorded under standard conditions. They are dependent on the loading of the dish racks. Variations are therefore possible in practice. 5) When the hardness setting is electronically adjusted to 10, the length of the dishwashing cycle may be slightly longer. 25 Operating Instructions Starting a dishwashing cycle 0 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. The LED in the ON/OFF button will become illuminated. Press the relevant button for the cycle required (see "Cycle Table"). The cycle display will become illuminated. 27 Operating Instructions Cancelling the start delay: As long as the dishwashing cycle has not begun you are able to cancel the start delay. Continue pressing the START DELAY button until the length of the selected dishwashing cycle appears in the multi-display. The selected dishwashing cycle will begin immediately. Changing the dishwashing cycle after the start delay has been set: As long as the dishwashing cycle has not started, you can still change the start delay set by pressing a cycle button. Press the button for the new dishwashing cycle and hold it down. First the indicator for the dishwashing cycle that has just been selected will flash. After several seconds only the indicator for the new dishwashing cycle will be flashing. The newly selected dishwashing cycle will start automatically following a countdown of the hours set. Load Sensing ­ Sensor Logic If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0. 2 kWh of electricity are saved. 28 Operating Instructions Switching Off the Dishwasher Only switch the dishwasher off when the multi-display indicates "0" remaining programme time. The ON/OFF button indicator extinguishes. 1 Hot steam may escape from the appliance when opening the door immediately after the end of the programme. [. . . ] 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Japan Electrolux Japan Ltd. Domestic Appliances Department Maruzen Showa Warehouse Building Tookai 4-5-12, Ota-ku 143-006 Tokyo Tel. : 0120-13-7117 Fax: 03-3790-5257 Thailand OLYMPIA Thai Ltd. 44 Ratchadapisek Road 10320 Bangkok Tel. : 2 513 6111 Fax: 2 513 2574 Hungary Electrolux Lehel KFT (AEG Div) Erzsébet Királyné útja 87. 1142 Budapest Tel. : 00361/467-3200 Slovakia Rep. [. . . ]