User manual AEG-ELECTROLUX FAV675I-W AN

[. . . ] With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 5 5 Prior to using for the first time . Adjusting the height of the upper basket. [. . . ] Depending upon the soiling, the temperature of the water will be automatically adjusted to between 50°C and 65°C. 3) When using this cycle, only load the dishwasher half full. 4) During the final rinse, the temperature is increased to 68° for 10 minutes to disinfect e. g. 6) This cycle does not need any detergent. 20 12 73 130 - 160 120 - 130 30 Starting a dishwashing cycle 1. Check that the spray arms can turn freely. The cycle indicator and the respective cycle stages in the cycle progress display will be illuminated. The remaining time expected for the cycle will be shown in the multi-display. The selected cycle will begin after approximately 3 seconds. The current stage of the cycle is always shown in the cycle progress display. During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to the size of the load, degree of soiling, etc. 3 Interrupting or aborting a dishwashing cycle Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 1 and 2 and keep them pressed. Turn the handle about ¼ of a turn anticlockwise (A) and remove the filter system (B). Take hold of the coarse and fine filters (1/2) by the handle and remove them from the micro-filter (3). Clean all filters thoroughly under running water. Remove the flat filter (4) from the base of the washing compartment and clean both surfaces thoroughly. Re-insert the flat filter. 23 1 7. Place the coarse and fine filters in the micro-filter and press together. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: ­ Fault codeÅ 10 (Problems with water inlet), ­ Fault codeÅ 20 (Problems with water drainage), please have a look at the following table. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. [. . . ] Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. [. . . ]