User manual AEG-ELECTROLUX FAV676D ITA

[. . . ] With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 5 5 Prior to using for the first time . Selecting the dishwashing cycle (Cycle Table) . [. . . ] Press function buttons 2 and 3 and keep them pressed. The programme display for the current cycle will flash for several seconds and then go out. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 20 Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. Press the Delay Timer button repeatedly until the indicator next to the number of hours for which the start of the dishwashing cycle is to be delayed lights up, e. 6h, if the cycle is to start in 6 hours. The LED indicator for the programme selected and the indicator next to the number of hours will light up. The dishwashing cycle will start automatically following a countdown of the hours set. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. If the fault is displayed again or if other faults are displayed, please contact the Customer Care Department and inform them of the fault display. 23 Malfunction Possible cause The tap is blocked or furred with lime-scale. The tap is turned off. Remedy Clean tap. Turn the tap on. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in rhythm 1 short light signal with approx. 3 second pause in-between: There is no water entering the dishwasher. The filter (where present) in Clean the filter in the the threaded hose fitting on threaded hose fitting. Press the button for the dishwashing cycle that has started; then abort the dishwashing cycle (see section: Starting a dishwashing cycle); clean filters (see section: Cleaning the filters). Clean out sink outlet. Filters in the base of the washing compartment are blocked. Water inflow hose has not been correctly positioned. The programme indicator for The sink outlet is blocked. the selected dishwashing cycle is flashing, the indicator for the end of Water drain hose has not the dishwashing cycle is been correctly positioned. flashing in rhythm 2 short light signals one after another. the indicator for the end of the dishwashing cycle is The anti-flood system has flashing in rhythm 3 short been triggered. The mains plug is not plugged in. Check hose installation. Turn off the tap and contact the Customer Care department. Plug in mains plug. The cycle is not starting. A fuse in the house's wiring Replace fuse. [. . . ] Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. [. . . ]