User manual AEG-ELECTROLUX FAV775IW

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. 5 5 7 7 Prior to Using for the First Time. 12 Activating/deactivating the acoustic signal . Adjusting the Height of the Upper Basket . [. . . ] 30 minute programme). 22 Starting a dishwashing cycle 1. Check that the spray arms can turn freely. Select the required programme by repeatedly pressing the programme button. The display for the selected programme lights up. The wash programme will begin. Interrupting or Cancelling a dishwashing cycle Interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press and hold the programme button for approx. The indicator for the end of the wash programme flashes. The dishwashing cycle has been cancelled. If you want to start a new dishwashing cycle, check whether there is any detergent in the dispenser. 23 Setting the delay timer With the delay timer you can delay the start of a dishwashing cycle for 3 hours. The delay timer indicator is illuminated. Close the door. The dishwashing cycle will start automatically when 3 hours have elapsed. Do not damage the jet opening. 3 Upper basket spray arm 1. To remove upper basket spray arm, tilt it down hard. Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 27 What to do if. . . Remedying small malfunctions If the acoustic signal is activated, warning tones sound if there are faults. If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. In the case of other fault messages: ­ Cancel the dishwashing cycle. ­ Switch the appliance off and on again. If the fault is displayed again, please contact the Service Force Centre and inform them of the fault message. Malfunction Possible cause Tap is blocked with limescale or is faulty. 1 short warning tone, continuously repeated, can be heard, the programme display for the selected wash programme is flashing: the indicator for the end of the wash programme is flashing once continuously . [. . . ] · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. [. . . ]