User manual AEG-ELECTROLUX FAV86070VI

[. . . ] FAVORIT 86070 VI Dishwasher User information Dear Customer, Please read this user information carefully and keep it to refer to later. Please pass the user information on to any future owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning!Information that affects your personal safety. Information that prevents damage to the appliance. [. . . ] If the dishwasher is built in at high level with flush fitting cupboard doors around it, the light signal cannot be seen. The dot shaped light signal is not dangerous. (It is not a laser. ) It lights up while a dishwasher cycle is running and goes out when the cycle ends. 3 3 Interrupting or Cancelling a dishwashing cycle Interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 2 and 3 and hold them down. The LED indicators of all the programme buttons that can be selected will illuminate. If you want to start a new wash programme, check whether there is any detergent in the dispenser. 26 Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi-display. The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First cancel the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Switching Off the dishwasher When the dishwasher cycle has ended, the dot-shaped light signal below the door of the appliance goes out. If the acoustic signal has been enabled, a continuous tone will sound for 15 seconds at the end of the dishwashing cycle. If the dishwasher door is not opened, the acoustic signal sounds again after 3 and 6 minutes. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. Hot steam may escape. 1 · Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about 15 minutes before removing them. · Dishes dry more quickly if you open the door for a moment after the cycle has ended and then leave it slightly open. 27 Removing the Dishes 3 It is normal for the inner door and the dispensers to be damp. · Empty the lower basket first, then the upper basket. [. . . ] · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. · Home visits are made between 8. 30am and 5. 30pm Monday to Friday. [. . . ]