User manual AEG-ELECTROLUX FAV86080VI

[. . . ] FAVORIT 86080 Vi The fully integratable dishwasher User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] The dot shaped light signal is not dangerous. (It is not a laser. ) It lights up while a dishwasher cycle is running and goes out when the cycle ends. 3 3 Interrupting or aborting a dishwashing cycle Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 2 and 3 and keep them pressed. The LED indicators of all the programme buttons that can be selected light up. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. 27 Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi-display. The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. 28 Switching off the dishwasher When the dishwasher cycle has ended, the dot shaped light signal below the door of the appliance goes out. If the acoustic signal has been enabled, a continuous tone will sound for approx. 15 seconds at the end of the dishwashing cycle. If the dishwasher door is not opened, the acoustic signal will repeat after 3 minutes and again after 6 minutes. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. Hot steam may escape. 1 Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about 15 minutes before removing them. Turn off the water tap. Removing the dishes 3 It is normal for the inner door and the dispensers to be damp. [. . . ] The guarantee does not apply to defects due to transport which have occurred outside of our responsibility. Nor will the guarantee cover those caused by inadequate installation or assembly, lack of maintenance or failure to respect the assembly instructions or directions for use. Defects that result from repairs or measures carried out by people who are not qualified or expert or defects that result from the addition of non-original accessories or spare parts are not covered by the guarantee. Appliances that are easy to transport may be delivered or sent to the consumer services department. [. . . ]