User manual AEG-ELECTROLUX FAV875I-GP-D

[. . . ] With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. Switching on for the first time ­ setting the language . Adjusting the height of the upper basket. [. . . ] 31 3 Aborting the dishwashing cycle 1. If you want to start a new dishwashing cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. Setting the delay start 3 With the delay start you can delay the start of a dishwashing cycle for between 1 and 19 hours. First of all set the delay start and then the desired dishwashing cycle. Go to the DELAY START option; see section "Adapting an option/setting". Set the period by which you wish to delay the start in hours. Press the OPTION button, to change to the Programmes menu. First of all the pre-set time delay until the start runs down. In the display you see the time remaining until the start of the dishwashing cycle. After the time delay until the start has elapsed, the dishwashing cycle starts automatically, the symbol goes out. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. Cleaning the spray arm jets Regularly check the jets in the spray arms for blockages. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Then rinse out the spray arm using a strong jet of water. Do not damage the jet opening. 3 Upper basket spray arm 1. To remove upper basket spray arm, tilt it down hard. Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 36 What to do if . . . Resetting the language You can reset the language of the display to the factory setting at any time. As well as the language, the CONTRAST1 and BRIGHTNESS settings are also reset. Press the RESET button repeatedly until the display in the display no longer changes. [. . . ] Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. AEG Showroom Shariati, Balatar as Safar Teheran / Iran Phone No. Service: 021 / 312 27 67 / 8 Poland Electrolux Poland Sp. Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. [. . . ]