User manual AEG-ELECTROLUX FAVCOMP.325IW

[. . . ] It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step for step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. Tips and instructions for the economical and environmentally conscious use of the appliance are marked with a clover leaf. [. . . ] 4) The consumption figures were determined under standard conditions. They are intended as a guide only and depend on the loading. For this reason figures may vary in practice. 5) When the hardness setting is electronically adjusted to 10, the length of the dishwashing cycle may be slightly longer. 26 Operating Instructions Starting a dishwashing cycle 0 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. The LED in the ON/OFF button will become illuminated. Press the relevant button for the cycle required (see "Cycle Table"). The cycle display will become illuminated. The remaining time for the cycle will be shown in the multi-display. The selected cycle will begin after approximately 3 seconds. 3 3 During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to amount of dishes, degree of soiling, etc. If an error message is displayed in the multi-display after the cycle has begun, please read the section "What to do if . . . ". Changing/interrupting/aborting a dishwashing cycle 3 Only change or interrupt a dishwashing cycle that is in progress if it is absolutely necessary. The selected cycle will begin after approximately 3 seconds. The function can no longer be changed after the cycle has begun. In this case the dishwashing cycle must be aborted by pressing RESET, and must then be reselected. 3 3 3 If the additional function has been selected once, it will remain activated for all subsequent wash cycles unless it is deactivated by pressing the button again. The cycles lengths given in the cycle table may change if the additional function is used. When changing from 3-in-1 dishwashing tablets to conventional detergent please be sure above all to take note of the last 3 points in the chapter "Using 3-in-1 dishwashing tablets". Setting or changing the start delay Using the start delay timer you can adjust when within the next 19 hours the dishwashing cycle is to begin. Continue pressing the DELAY TIMER button b until the number of hours' delay until the dishwashing cycle is to start is flashing in the multi-display. Press the button for the desired dishwashing cycle. The length of the selected dishwashing cycle will flash for a moment in the multi-display, and then it will display the selected starting time again. As soon as the number of hours is displayed without flashing, the start delay has been activated. The dishwashing cycle will start automatically following a countdown of the hours set. Changing the start delay: As long as the dishwashing cycle has not started, you can still change the start delay set by pressing the DELAY TIMER button. [. . . ] In this event, we reserve the right to ask for a financial contribution calculated according to the length of time it has been used. A repair under guarantee does not mean that the normal guarantee period will be extended nor that a new guarantee period begins. We give a twelve month guarantee for repairs, limited to the same defect. Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. [. . . ]