User manual AEG-ELECTROLUX FAVCOMP.625ID

[. . . ] 4 4 6 6 Prior to using for the first time . Adjusting the height of the upper basket. Selecting the dishwashing cycle (Cycle Table) . 13 13 17 18 19 20 22 23 23 Care and cleaning . [. . . ] Press the Delay Timer button repeatedly until the multi-display shows the desired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi-display. The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Switching off the dishwasher Do not switch off the dishwasher until the multi-display indicates "0" for the remaining cycle time. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. · Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about 15 minutes before removing them. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. ­ Switch the appliance off and on again. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. Malfunction Possible cause Water tap is blocked with limescale or faulty. The cycle indicator for the selected dishwashing cycle is flashing: fault code Å 10 is displayed in the multi-display: (Problems with water inlet) Remedy Check the water tap and have it repaired if necessary. Turn the tap on. The filter (where present) in Clean the filter in the the threaded hose fitting threaded hose fitting. Cancel the dishwashing cycle (see chapter: Starting a dishwashing cycle), clean filters (see chapter: Cleaning the filters), then start the dishwashing cycle again. Filters in the base of the dishwasher compartment are blocked. Water inlet hose Check the position of the has not been correctly posihose. The cycle indicator for the selected dishwashing cycle is flashing, fault code Å 20 is displayed in the multi-display. (Problems with water drainage) The sink outlet is blocked. Clean out sink outlet. Water drain hose Check the position of the has not been correctly posihose. tioned. 27 Malfunction Fault code Å 30 is displayed in the multi-display. Possible cause The anti-flood system has been triggered. [. . . ] The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. The guarantee does not apply to defects due to transport which have occurred outside of our responsibility. [. . . ]