User manual AEG-ELECTROLUX FAVCOMP525ID-10

[. . . ] 5 5 7 7 Prior to using for the first time . Adjusting the height of the upper basket. Selecting the dishwashing cycle (Cycle Table) . 14 14 17 18 19 20 22 22 23 Care and cleaning . [. . . ] The dishwashing cycle will start automatically following a countdown of the hours set. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the delay timer: Press the DELAY TIMER button repeatedly until none of the three time displays is lit. The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Switching off the dishwasher Do not switch off the dishwasher until the indicator for the end of the dishwasher cycle is illuminated in the cycle progress display. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. Therefore leave the dishes to cool for about 15 minutes before removing them. You also get a better drying result. 1 Removing the dishes 3 It is normal for the inner door and the dispensers to be damp. · Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket. 23 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault message. Malfunction Possible cause The tap is blocked or furred with lime-scale. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in rhythm 1 short light signal with approx. 3 second pause in-between: (Problems with water inlet) Remedy Clean tap. Turn the tap on. The filter (where present) in Clean the filter in the the threaded hose fitting on threaded hose fitting. Cancel the dishwashing cycle (see chapter: Starting a dishwashing cycle), clean filters (see chapter: Cleaning the filters), then start the dishwashing cycle again. Clean out sink outlet. Filters in the base of the washing compartment are blocked. Water inflow hose has not been correctly positioned. The programme indicator for The sink outlet is blocked. the selected dishwashing cycle is flashing, the indicator for the end of Water drain hose has not the dishwashing cycle is been correctly positioned. flashing in rhythm 2 short light signals one after another. Check hose installation. 27 Malfunction Possible cause Remedy Turn off the tap and contact the Customer Care department. the indicator for the end of the dishwashing cycle is The anti-flood system has flashing in rhythm 3 short been triggered. The mains plug is not plugged in. Plug in mains plug. The cycle is not starting. A fuse in the house's wiring Replace fuse. For dishwasher models with If the dishes are to be a delay start timer: washed immediately, A start time has been selectcancel the delay start. [. . . ] The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. The guarantee does not apply to defects due to transport which have occurred outside of our responsibility. [. . . ]