User manual AEG-ELECTROLUX FAVCOMP525IM GB

[. . . ] 5 5 7 7 Prior to using for the first time . 12 Activating/deactivating the acoustic signal . Adjusting the height of the upper basket. Selecting the dishwashing cycle (Cycle Table) . [. . . ] The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Switching off the dishwasher If the acoustic signal has been enabled, a continuous tone will sound for approx. 15 seconds at the end of the dishwashing cycle. If the dishwasher door is not opened, the acoustic signal will repeat after 3 minutes and again after 6 minutes. Hot steam may escape. 1 Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about 15 minutes before removing them. Turn off the water tap. Removing the dishes 3 It is normal for the inner door and the dispensers to be damp. · Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket. 26 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth and clean warm water. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault message. Malfunction Possible cause Tap is blocked with limescale or is faulty. 1 short warning tone, continuously repeated, can be heard, the programme display for the selected wash programme is flashing: the indicator for the end of the wash programme is flashing once continuously . Remedy Check the tap and have it repaired, if necessary. Turn on the tap. The filter (where present) in Clean the filter in the the threaded hose fitting threaded hose fitting. Cancel the dishwashing cycle (see chapter: Starting a dishwashing cycle), clean filters (see chapter: Cleaning the filters), then start the dishwashing cycle again. Check the position of the hose. Filters in the base of the washing compartment are blocked. Water inflow hose has not been correctly positioned. 30 Malfunction Possible cause Remedy Clean the siphon. 2 short warning tones, The siphon is blocked. continuously repeated, can be heard, the programme display for the selected wash programme is flashing, the indicator for the end Water drain hose has not of the wash programme is been correctly positioned. (Rinse water has collected in the dishwasher's interior container). 3 short warning tones, continuously repeated, can be heard, The anti-flood system has the indicator for the end been triggered. of the wash programme is flashing three times continuously . The programme is not starting. Check the position of the hose. First turn off the water tap, then switch off the appliance and contact customer service. Connect the plug to a mains socket. A fuse in the house's wiring Replace fuse. [. . . ] 7 54 1 Chausee Street Port Louis Tel. : 25355 Namibia AEG NAMIBIA (PTY) LIMITED-Jeppe Street Northern Industrial Area Windhoek Tel. : (061) 21-6082/4 Fax: (061) 217838 New Zealand Monaco Corporation Ltd. 10 Rothwell Avenue Albany - Auckland 4399 Auckland 1 New Zealand Tel. : 0064 94156019 Fax: 0064 94157070 Syria WATTAR CO. Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. AEG Showroom Shariati, Balatar as Safar Teheran / Iran Phone No. [. . . ]