User manual AEG-ELECTROLUX FDBB944CB

[. . . ] Dishwasher Product Registration Card Please fill in completely, sign and return promptly! Use & Care Manual 950 Series Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . 2 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Normal Operating Sounds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . 4-6 Preparing and Loading Dishes. . . . . . . . . . . . . . . . . [. . . ] Close the door to latch and the dishwasher will continue through the cycle. 10 Dishwasher Dispenser & Detergents (continued) Rinse Aid Rinse aid greatly improves drying and reduces water spots and filming. Water "sheets" off dishes rather than forming water droplets that cling and leave spots. A dispenser, located next to the detergent cup, automatically releases a measured amount of rinse aid during the last rinse. If spotting and poor drying are problems, increase the amount of rinse aid dispensed by rotating the dial to a higher number. The dial is located under the dispenser cap. The indicator will be dark when full and will show clear when it is time to refill. To add liquid rinse aid, turn dispenser cap 1/4 turn counterclockwise and lift out. Pour in rinse aid until liquid touches the indicated fill level. Do not overfill since this can cause oversudsing. The dispenser holds enough for 35 to 140 washes, depending on setting. Dispenser Opening Indicator Factors Affecting Performance Water Pressure The hot water line to dishwasher must provide water pressure between 20 and 120 psi. Low water pressure may occur when laundry or showers are in operation. Wait until water use is reduced before starting dishwasher. Water Temperature Hot water is needed for best dishwashing and drying results. Water entering dishwasher should be at least 120°F (49°C) to give satisfactory results. To check water temperature entering dishwasher: · Turn on hot water faucet nearest dishwasher for several minutes to clear cool water from pipes. · Hold a candy or meat thermometer in stream of water to check the temperature. · If temperature is below 120°F (49°C), have a qualified person raise the hot water heater thermostat setting. Important: Before starting a cycle, run hot water to clear cool water from pipe. Adjustable setting Dispenser Cap 11 Care and Cleaning Care of Drain Air Gap Burn Hazard Allow heating element to cool before cleaning the interior. If a drain air gap was installed for your built-in dishwasher, check to make sure it is clean so the dishwasher will drain properly. A drain air gap is usually mounted on countertop and can be inspected by removing the cover. This is not part of your dishwasher and is not covered by warranty. Outside--Occasionally wipe with a mild nonabrasive detergent and water. Rinse and dry. Models with Stainless Steel Door-- Clean stainless steel door with Stainless Steel Magic, trademark of Magic American Corp. , or similar product using a clean, soft cloth. Avoid harsh or gritty cleaners or scouring pads which may scratch the finish. Inside--The inside of the dishwasher is selfcleaning with normal use. [. . . ] Proper installation by an authorized servicer in accordance with instructions provided with the appliance and in accordance with all local plumbing, electrical and/or gas codes. Proper connection to a grounded power supply of sufficient voltage, replacement of blown fuses, repair of loose connections or defects in house wiring. Expenses for making the appliance accessible for servicing, such as removal of trim, cupboards, shelves, etc. , which are not a part of the appliance when it was shipped from the factory. Replacement of light bulbs and/or fluorescent tubes (on models with these features). [. . . ]