User manual AEG-ELECTROLUX FH64.1GDD

[. . . ] Along with a wide range of accessories designed and built to the high quality standards you would expect, from specialist cookware to cutlery baskets, from bottle holders to delicate laundry bags. The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. Before the installation and use, read this manual carefully: · For your safety and the safety of your property. Always keep these instructions with the appliance also if you move or give it to a different person. [. . . ] ⷠIf the programme marker is not aligned with a washing programme, the display shows two horizontal status bar. To deactivate the appliance Turn the programme knob until the programme marker is aligned with the off position. The appliance must be in setting mode for these operations: · One or more phase indicator lights come on. One or more phase indicator lights come on. Use of the appliance ­ It is necessary to cancel the programme or the delay start to go back to the setting mode (refer to 'Select and start a washing programme'). Be sure that the set level of the water softener agrees with the water hardness in your area. Fill the salt container with dishwasher salt. Fill the rinse aid dispenser with rinse aid. Load cutlery and dishes into the appliance. Set the correct washing programme for the type of load and soil. Fill the detergent dispenser with the correct quantity of detergent. Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Do these steps to fill the rinse aid dispenser: 1. Fill the rinse aid dispenser 4 with rinse aid. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. Press the lid until it locks into position. You can set the rinse aid dosage between position 1 (lowest dosage) and position 6 (highest dosage). Some types of tablets can contain other agents. Be sure that these tablets are applicable for the water hardness in your area (refer to the instructions on the packaging of the products). The programme duration can increase if you use the multitab function. activate the multitab function before the start of a washing programme. [. . . ] Put the coarse filter (A) in the microfilter (B) and push the filters together. Turn the handle on the microfilter (B) clockwise until it locks in position. Release the Multitab button when the display shows the set level of the water softener. Turn the programme knob counterclockwise until the programme marker is aligned with the second washing programme on the control panel. [. . . ]