User manual AEG-ELECTROLUX FM2500DD-A

[. . . ] INSTRUCTION BOOK FM 2500DD-A GB 40 325 88-8514 rev. 6-437 949 601 706 Your New Appliance Thank you for purchasing an AEG appliance. To enable you to use your new appliance efficiently and safely, please read this instruction book carefully before installing or using the appliance, and retain for future reference. Should the appliance be transferred to a new owner please ensure this instruction book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. [. . . ] The dampers will deploy on the way up. Mounting: When mounting several hobs together you must use a reinforcement beam between each hob as well as the silicone supplied with the hobs (see fig. ) 1. Cut a hole of the calculated size in the table top 2. Place the individual hobs upside down on a mat. Take care that the top side is not scratched. Mount the clamping fittings in the holes in the side of the base panels (see fig. ) 4. Apply silicone to the two corners joining the next hob (see fig. ) Use only the silicone supplied with the hobs as this is intended to tolerate the high temperatures of the appliance. Push a reinforcement beam up against the hob. Apply silicone on the reinforcement beam (see fig. ) 7. Tighten the clamping fittings to the table top using a screwdriver. Repeat the process for the other hobs. m Safety If the downdraught extractor is obstructed on the way up, it will switch off automatically. Press l. Extraction will be turned off. The downdraught extractor will stop when you release the button. Pressing will turn extraction off, but the downdraught extractor will remain where it is and not descend into the worktop. k Silikonet 12 29 Mounting more than one hob Extraction rates The downdraught extractor can be set to three levels and intensive extraction. Level 1: 150 m³/h Level 2: 220 m³/h Level 3: 345 m³/h Intensive extraction: 480 m³/h Setting the extraction rate When the downdraught extractor is on, raised and at rate 1. Press one press = level 2 two presses = level 3 Adjusting the extraction rate The extraction rate can be adjusted by pressing . Distance to wall: Min. 150 mm (flammable material) Distance to wall: Min. 50 mm (non-flammable material) Reinforcement beam m 0m 49 < Cutting out The measurement of the selected combination is calculated in the following way: Depth: 490 mm Width: 1. Calculate the sum of all units' width. Example: A hob of 720 mm + a downdraught of 180 mm + a gas hob of 360 mm. Width of the hole: 1260-20=1240 mm Distance to Wall: Min. 50 mm to non-flammable material < Switching extraction off Press until the display shows 0. < 28 13 Intensive extraction The downdraught extractor is on and raised. Press Cutting Out When fitting this product: read the instructions on this page. [. . . ] cable size: 0. 75 mm² Cable type: HO5VV-F Installation must comply with any special requirements laid down by the local energy provider. The product must be connected via an external switch that disconnects all poles with a contact gap of at least 3 mm. (May be the main switch). L L1 N PE N L2 Aluminium Carry out daily cleaning with a well wrung-out cloth. For more stubborn soiling, use a cloth or a soft plastic sponge together with washing-up liquid or all-purpose cleaner. [. . . ]