User manual AEG-ELECTROLUX FM4300GAN

[. . . ] INSTRUCTION BOOK FM 4300G-an GB 325 88-8522 rev. 3-347 949 601 206 Your New Appliance Thank you for purchasing an AEG appliance. To enable you to use your new appliance efficiently and safely, please read this instruction book carefully before installing or using the appliance, and retain for future reference. Should the appliance be transferred to a new owner please ensure this instruction book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. [. . . ] Pleace note that it will be necessary to provide proof of purchase for any inguarantee service calls. 6 27 Product Description Overview of the outside width of the units 180 mm Downdraft 360 mm Glass ceramic hob with 2 cooking zones Gas hob with 2 burners Induction hob with 2 cooking zones Grill Grill / Fryer Wok 580 mm Glass ceramic hob with 4 cooking zones Gas hob with 4 burners 720 mm Glass ceramic hob with 4 cooking zones Gas hob with 4 burners Induction hob with 4 cooking zones 1. Control panel Control Panel 2 1 1. Control knob for rear burner 26 7 Ceramic hob Ceramic glass is insensitive to temperature shock and very robust: however it is not unbreakable. Especially sharp and hard objects that fall on the cooking surface can damage it. To optimise joints between the installed hobs, the gap between the ceramic hob may be grouted with silicone: 1. Remove the aluminium panels from the hobs. Apply a stripe of silicone to the gap between the two ceramic hob. Use only the silicone supplied, as it is designed to tolerate the appliance's high temperature. Splash a little soapy water (washing-up liquid) on the silicone stripe 4. Press the rubber block hard against the ceramic hob and pull it slowly from back to front (Fig. Leave the silicone to harden until the next day. Remove surplus silicone coating from the ceramic hob with the razorblade supplied. Be careful not to damage the silicone in the gap. Run tools only along the joint, never across it. Never leave the hob unattended when deep frying or melting fat, paraffin wax or other easily ignited substances. Never leave paper, dish cloths, aluminium foil or any other easily ignited materials in the immediate vicinity of the hob. A hot hob can cause foil, plastic or paper to melt or burn. In case of fire, turn off all knobs and switch off any cooker hood. Extinguish the fire with a fire blanket or dampened cloth. Scrape any spillages from the hob immediately, using a hob scraper if necessary. Spillages of sugar and sugarrich foods (jam, fruit syrup etc. ), melted plastic and aluminium foil can damage the hob. Distance to wall: Min. 150 mm (flammable material) Distance to wall: Min. 50 mm (non-flammable material) Reinforcement beam m 0m 49 Cutting out The measurement of the selected combination is calculated in the following way: Depth: 490 mm Width: 1. [. . . ] Use a cleaning agent designed for ceramic hobs. Follow the instructions on the container. 14 19 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice: B. S. The hob should not be installed in a bed sitting room with a volume of less than 20 m³. [. . . ]