User manual AEG-ELECTROLUX FM6520K-AN

[. . . ] FM 6520 K-AN User manual Ceramic glass hob 2 Dear Customer Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] by a pan placed upon it, a signal sounds and the cooking surface switches off automatically. If all cooking zones are switched off, the cooking surface automatically switches itself off after approx. a wet cloth) or liquid boiling over onto the control panel immediately switches all cooking zones off. Cooking zones If one of the cooking zones is not switched off after a certain time, or if the heat setting is not modified, the relevant cooking zone switches off automatically. Before being used again, the cooking zone must be set to 3 . Heat setting v, 1 - 2 3-4 5 6-9 Switches off after 6 hours 5 hours 4 hours 1. 5 hours 14 Tips on Cooking and Frying Tips on Cooking and Frying 3 Information on acrylamides According to the latest scientific knowledge, intensive browning of food, especially in products containing starch, can constitute a health risk due to acrylamides. Therefore we recommend cooking at the lowest possible temperatures and not browning foods too much. Cookware You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Energy saving 2 2 2 2 Always place cookware on the cooking zone before it is switched on. If possible, always place lids on the pans. Switch cooking zones off before the end of the cooking time, to take advantage of residual heat. Rub the appliance dry using a clean cloth. Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discolouration immediately yes yes ------when the appliance has cooled down ----yes yes yes cleaner for glass ceramic or stainless steel* using a scraper* *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialist shops 3 3 Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. Removable Frontline strip The aluminium Frontline strip fastens on by means of magnets. It is easy to remove by hand and can be cleaned with detergent. Please do not use any scouring agents or sponges that scratch. Do not clean the strip in the dishwasher. What to do if . . . 17 What to do if . . . Problem Possible cause Remedy The cooking zones will not More than 10 seconds have Switch the appliance on again. switch on or are not function- passed since the appliance was ing switched on The child safety device is switched on l Several sensor fields were touched at the same time The sensor fields are partly covered by a damp cloth or with liquid Deactivate the child safety device (See the section "Child safety device") Only touch one sensor field Remove the cloth or the liquid. Switch the appliance on again. Automatic switch off has been Switch the appliance on again triggered STOP+GO is activated u The residual heat indicator is not displaying anything Switching off STOP+GO The cooking zone was only on If the cooking zone is supfor a short time and is there- posed to be hot, call the Cusfore not hot tomer Service Department. The highest heat setting has the same power as the automatic warm-up function Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department The automatic warm-up func- The highest heat setting is set tion is not switching on e and number are displayed Electronics fault 1 3 If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. 18 Disposal Disposal 2 Packaging material The packaging materials are environmentally friendly and can be recycled. The plastic components are identified by markings, e. g. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. 2 Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] Inject a line of silicon into the gap between the appliances. Dampen silicon line with a little soapy water. Press rubber block hard against the glass ceramic and draw it slowly along the gap. 13. 16. Leave silicon until the next day to harden. [. . . ]