User manual AEG-ELECTROLUX FN38EN

[. . . ] NECO MODEL AMENDMENT SHEETS NECO MODEL FN38LP/NG Amendment Pages (Use these pages in place of standard manual) Grill Assembly Built-In Instructions 5-12 13-15 16-19 17 20 21-22 23 Welcome & Congratulations Congratulations on your purchase of a new gas grill!At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. Your satisfaction is our number one priority. We know you'll enjoy your new gas grill and Thank You for choosing our product. [. . . ] Any joint sealant used must be an approved type and be resistant to the actions of L. P. Attach the natural gas regulator (supplied with your grill) to the brass fitting coming out the bottom, backside of the grill (be sure the arrow on the regulator is pointing up towards the grill). Attach your gas line to the 3/8" flare fitting coming out of the natural gas regulator at the back of the grill. Place the installer supplied shut-off valve in an accessible location to enable the gas supply to be cut off to the unit. Gas Installation Frigidaire Gas Grills that are set to operate with L. P. gas come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). This assembly is designed to connect directly to a standard 20 lb. Attach the gas hose assembly to the brass 3/8 flared fitting using an adjustable wrench on the under side of the grill. Tighten securely and attach other end to the propane tank. 24) LP hose/ regulator supplied with grill. Tank Information Never use a dented or rusted L. P. cylinder must be provided with a shut-off valve terminating in an L. P. gas supply cylinder outlet specified, as applicable, for connection No. 510 in the standard for compressed gas cylinder valve outlet and inlet connection ANSI/CGA-V-1. Cylinders must not be stored in a building, garage, or any other enclosed area. cylinder must have an overfill protection device, OPD, on it. ) The L. P. Gas supply cylinder must be constructed and marked in accordance with the specifications for L. P. Department of Transportation (DOT) or the National Standard of Canada, CAN/CAS-B339, "Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods. " ·When not in use, gas supply cylinder valve is to be in the "OFF" position. ·The tank supply system must be arranged for vapor withdrawal. (LP Tank must be kept in an upright position. ) ·The regulator and hose assembly must be inspected before each use of the grill. If there is excessive abrasion or wear or if the hose is cut, it must be replaced prior to the grill being used again. [. . . ] Check tank fuel level. Grill will not light when the ignitor button is pushed. Check for loose wire connections. Remove the cooking grates and flavor grids. Push ignitor button, and check for spark on tip of electrode. Check to see if debris is blocking the electrode sparks. [. . . ]