User manual AEG-ELECTROLUX FRIG819042060EN

[. . . ] USE & CARE MANUAL THIS AIR CONDITIONER IS EQUIPPED WITH A NEW INDUSTRY STANDARD POWER SUPPLY CORD WITH A TEST-RESET FUNCTION READ AND SAVE THESE INSTRUCTIONS AIR CONDITIONER MULTI-STEP SPEED ELECTRONIC CONTROLS P/N819042060-01 ROOM AIR CONDITIONER WARRANTY Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this warranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer. [. . . ] A new one can be obtained from the product manufacturer. If power supply cord is damaged, it CANNOT be repaired. It MUST be replaced by one obtained from the product manufacturer. Air Conditioner Features Control panel AUTO COOL FEATURE CLEAN AIR FEATURE (SOME MODELS) ELECTRONIC CONTROL OPERATING INSTRUCTIONS Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the control panel alone or with the remote. SETS FAN SPEEDS SLEEP MODE CHECK FILTER RESET BUTTON Remote with digital display & remote sensing feature TURNS UNIT ON OR OFF LIGHT SETS FAN SPEEDS Temp /Timer Fan Slower AUTO ADJUSTS TEMPERATURE OR TIME Sleep Fan Faster Auto Cool Clean Air Check Filter Heat Fan Energy Saver Cool Temp /Timer REMOTE TEMP. SENSING INDICATOR (SOME MODELS) SETS MODE Timer Remote Sensing Mode On/Off SETS MODE ADJUSTS TEMPERATURE OR TIME ACTIVATES TURNS UNIT ON OR OFF TIMER ACTIVATES REMOTE THERMOSTAT (some models) ACTIVATES TIMER Remote for HEAT models LIGHT TURNS UNIT ON OR OFF Standard remote LIGHT TURNS UNIT ON OR OFF ADJUSTS TEMPERATURE OR TIME SETS FAN SPEEDS SETS MODE HEAT MODE Heat ADJUSTS TEMPERATURE OR TIME SETS FAN SPEEDS ACTIVATES TIMER SETS MODE ACTIVATES TIMER Battery Size: AA WARNING: Do Not Mix Old And New Batteries. Do Not Mix Alkaline, Standard (Carbon-Zinc), Or Rechargeable (Nickel-Cadmium) Batteries. For example if the room does not get too warm, it will stay at the slowest speed. If the room temperature rises quickly, such as a door being opened, it will automatically go to the highest speed. The fan speeds will re-adjust back to the slowest speed as the room returns to the original set temperature. Press either the fan slower or fan faster button to adjust the fan speed manually. TO OPERATE ON FAN ONLY: Temp /Timer YOU WILL SEE: Temp /Timer Fan Slower Fan Slower Fan Faster Fan Faster AUTO Auto Cool Clean Air Sleep Check Filter LIGHT ON AUTO Auto Cool Clean Air Sleep Check Filter Heat Fan Energy Saver Cool Temp /Timer Heat Fan Energy Saver Cool Temp /Timer Timer Remote Sensing On/Off Mode Timer Remote Sensing On/Off Mode DO THIS: PRESS MODE BUTTON CHOOSE FAN NOTE: Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air. (Remember to open vent during this function, but keep it closed during cooling for maximum cooling efficiency. ) You can choose any fan speed you prefer. During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. TO USE THE ENERGY SAVER FEATURE: Temp /Timer YOU WILL SEE: Temp /Timer Fan Slower Fan Slower Fan Faster Fan Faster AUTO AUTO Auto Cool Clean Air Sleep Check Filter Heat Fan Energy Saver Cool Temp /Timer LIGHT ON Auto Cool Clean Air Sleep Check Filter Heat Fan Energy Saver Cool Temp /Timer Timer Remote Sensing On/Off Mode Timer Remote Sensing On/Off Mode DO THIS: PRESS MODE BUTTON CHOOSE ENERGY SAVER NOTE: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling starts. 7 Air Conditioner Features (continued) TIMER: DELAY STOP/START FEATURE: Temp /Timer YOU WILL SEE: Temp /Timer Fan Slower Fan Slower Fan Faster Fan Faster AUTO AUTO Auto Cool Clean Air Sleep Check Filter Auto Cool Clean Air Sleep Check Filter LIGHT ON Heat Fan Energy Saver Cool Temp /Timer Heat Fan Energy Saver Cool Temp /Timer Timer Remote Sensing On/Off Mode Timer Remote Sensing On/Off Mode THEN DO THIS: PRESS UP ( ) OR DOWN ( ) BUTTON DO THIS: PRESS TIMER BUTTON NOTE: For Delay Stop, the unit must be in the ON position. NOTE: For Delay Start, the unit must be in the OFF position. To adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay timer at . 5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7. 5, 7, etc. ). The Delay Start mode automatically selects cooling at High Fan Speed. The temperature maintained will be the same as previously set. To change the set temperature, press "COOL " then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. [. . . ] To defrost, set selector to FAN ONLY mode. Temperature is too low for night-time cooling. To defrost the coil, set to FAN ONLY mode. Then, set temperature to a higher number. Air conditioner cooling, but room is too warm-NO ice forming on cooling coil behind decorative front. Dirty air filter-air restricted. [. . . ]