User manual AEG-ELECTROLUX FRIGTTW309000856EN

[. . . ] OWNER'S GUIDE READ AND SAVE THESE INSTRUCTIONS THRU-THE-WALL AIR CONDITIONER ELECTRONICCONTROL ELECTRONIC CONTROL P/N 309000856 (11/03) ROOM AIR CONDITIONER WARRANTY Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this warranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer. WARRANTY PERIOD FULL ONE-YEAR WARRANTY FRIGIDAIRE, THROUGH ITS AUTHORIZED SERVICERS, WILL: THE CONSUMER WILL BE RESPONSIBLE FOR: One year from original Pay all costs for repairing or replacing parts of this Costs of service calls that are listed under NORpurchase date. [. . . ] · Do not run air conditioner with outside protective cover in place. This could result in mechanical damage within the air conditioner. · Do not use an extension cord or an adapter plug. Power supply cord with 3-prong grounding plug Energy Saving Ideas · Do not block air flow inside with blinds, curtains or furniture; or outside with shrubs, enclosures, or other buildings. · The capacity of the room air conditioner must fit the room size for efficient and satisfactory operation. · Install the room air conditioner on the shady side of your home. A window that faces north is best because it is shaded most of the day. · Close the fireplace damper, floor and wall registers so cool air does not escape up the chimney and into the duct work. · Keep blinds and drapes in other windows closed during the sunniest part of the day. · Clean the air filter as recommended in the section "Care and Cleaning. " · Proper insulation and weather stripping in your home will help keep warm air out and cool air in. · External house shading with trees, plants or awnings will help reduce the air conditioner's work load. · Operate heat producing appliances such as ranges, washers, dryers and dishwashers during the coolest part of the day. 4 Using Air Conditioner NOTE: If the air conditioner is turned off or the temperature is changed to a lower setting then back to a higher setting the compressor will shut off. Wait 3 minutes before the compressor will restart, this allows for the pressure inside the compressor to equalize. . Failure to wait 3 minutes may cause inefficient operation when adjusting the temperature the fan will continue to run. To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. To begin operating the air conditioner or heater, follow these steps: 1. (To prevent electrical hazards, do not use an extension cord or an adapter plug. ) 2. Press "On/Off" button to turn unit on. Press "COOL" Mode for air conditioning, or press "HEAT" Mode for heater. Press "TEMP/TIME" down V or up ^ to the desired set temperature. Review the "Air Conditioner Features" section for other settings. Air Conditioner Features ON/OFF ELECTRONIC CONTROL OPERATING INSTRUCTIONS Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions. Then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote. RAISES TEMPERATURE OR TIME SELECT FAN SPEEDS TURNS UNIT ON OR OFF LOWERS TEMPERATURE OR TIME SETS MODE TIMER DISPLAYS TEMPERATURE/TIME SLIDE BATTERY COVER OF REMOVE THE TAB REMOTE CONTROL 5 Air Conditioner Features (continued) TO TURN UNIT ON: YOU WILL SEE: DO THIS: PRESS ON/OFF BUTTON TO CHA NGE TEM PERATURE SETTING: Y OU W ILL SEE: DO THIS: PRESS TO RAISE PRESS TO LOWER Note: Tap or hold either up(^) or down(v) button until the desired temperature is seen on display. This temperature will be automatically maintained anywhere between 60F (16C) and 90F (32C) for cooling mode. The Temperature will be automatically maintained anywhere between 55F (13C) and 80F (27C) for heating mode. If you want the display to read the actual room temperature, "FAN SEE ONLY MODE". TO CHANGE FAN SPEEDS: DO THIS: PRESS FAN SPEED BUTTON SELECT SPEED YOU WILL SEE THE SPEED CHOSEN: TO USE AUTO FAN FE ATURE: YOU WILL SEE: DO THIS: PRESS FAN SPEED BUTTON SELECT AUTO FAN Note: The fan speed will begin in HI, then adjust to MED and LO as the room temperature conditions indictates. [. . . ] House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker. Turn Control ON and set to desired FAN or COOL setting. Unit turned off and then on too quickly, wait 3 minutes before compressor will automatically restart. [. . . ]