User manual AEG-ELECTROLUX GA60GLV221

[. . . ] You've chosen a product that brings with it decades of professional experience and innovation. ingenious and stylish , it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you'll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. [. . . ] These tablets contain detergent, rinse aid and other added agents. Be sure that these tablets are applicable to the water hardness in your area. The dishwasher salt keeps the water softener clean and in good conditions. refer to the table to adjust the water softener to the right level. It makes sure that the water softener uses the correct quantity of dishwasher salt and water. Example: five intermittent acoustic signals = level 5. â· The display shows the setting of the = level water softener. Press button (3) again and again to change the setting. Other products can cause damage to the appliance. Water and salt can come out from the salt container when you fill it. Put 1 litre of water in the salt container (only for the first time). Fill the salt container with dishwasher salt. Remove the salt around the opening of the salt container. Turn the cap clockwise to close the salt container. Other products can cause damage to the appliance. The rinse aid, during the last rinsing phase, helps to dry the dishes without streaks and stains. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. Make sure that the release button locks into position. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). Set and start the correct programme for the type of load and soil. The beer glass holders prevent the beer glasses to move while a programme operates. [. . . ] Put the filter (B) to its initial position. Make sure that it assembles correctly under the two guides (C). Assemble the filter (A) and put it into position in filter (B). If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. [. . . ]