User manual AEG-ELECTROLUX GA60LXI101

[. . . ] user manual Dishwasher GA60LXI101 2 electrolux Electrolux. Thinking of you. Share more of our thinking at www. electrolux. com Contents Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Product description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To deactivate the function press the same buttons again until the indicator light corresponding to the Multitab function symbol goes off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid is only possible with the Multitab function active. Activation/deactivation of the rinse aid dispenser 1. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. 3. Press function button B, the lights of function buttons A and C go off while the light of function button B continues to flash. To activate the rinse aid dispenser, press button B again, the End indicator light comes on, indicating that the rinse aid dispenser has been activated. To memorize the operation, switch off the dishwasher by pressing the On/Off button. To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light goes off. If you decide to revert back to the use of individual detergents we advise that you: 1. Fill up the salt container and the rinse aid dispenser again. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. Select and start a washing programme Select the washing programme with the door slightly opened. The start of the programme will occur only after the closure of the door. Until then it is possible to modify the settings 1. Check that the baskets have been loaded correctly and that the spray arms are free to rotate. Press the button corresponding to the required programme (see ''Washing programmes'' chart). When a programme has been selected the corresponding light comes on. The phase indicator lights foreseen for the set programme start flashing. Close the dishwasher door, the programme starts automatically. [. . . ] The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal di- Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. To avoid water leakage after installation make sure that the water couplings are tight. 22 electrolux Electrical connection Warning! [. . . ]