User manual AEG-ELECTROLUX GA60LXI102

[. . . ] Safety information Product description Control panel First use Setting the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function 67 69 70 71 71 72 73 74 75 77 78 Select and start a washing programme Unloading the dishwasher Washing programmes Care and cleaning What to do if. Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] After loading your machine always close the door, as an open door can be a hazard. To move to the higher position proceed as follows: 1. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. Only use detergents specifically designed for use in dishwashers. please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. Fill the detergent dispenser (1) with detergent. Close the lid and press until it locks in place. Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Simultaneously press and hold function buttons B and C , until the lights of function buttons A , B , and C start flashing. Press function button B , the lights of function buttons A and C go off while the light of function button B continues to flash. To activate the rinse aid dispenser, press button B again, the End indicator light To deactivate the rinse aid dispenser again, follow the above instructions until the End indicator light goes off. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. When a programme has been selected the corresponding light comes on. the phase indicator lights foreseen for the set programme start flashing. Close the dishwasher door, the programme starts automatically. Once the programme starts, the phase indicator lights go off except for the indicator light of the phase in progress which will remain on with a static light. The selection of the washing programme can also occur with the door closed. Keep in mind that in this way, once a washing programme button is pressed, you have ONLY 3 seconds in which you can choose another programme after which the selected programme will start automatically. [. . . ] Water drain connection The end of the drain hose can be connected in the following ways: 1. to the sink outlet spigot , securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. If you use a drain hose extension, its internal diameter must be no smaller than the diameter of the hose provided. [. . . ]