User manual AEG-ELECTROLUX GL51EN

[. . . ] 51" Gallery Series Grill Assembly Built-In Instructions 4-8 9-11 12-15 13 16 17-18 19 We know you'll enjoy your new gas grill and Thank You for choosing our product. We hope you consider us for future purchases. PLEASE CAREFULLY READ AND SAVE THESE INSTRUCTIONS Congratulations on your purchase of a new gas grill!At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. [. . . ] tank or cylinder with a damaged valve. ·When not in use, gas supply cylinder valve is to be in the "OFF" position. ·The tank supply system must be arranged for vapor withdrawal. (LP Tank must be kept in an upright position. ) ·The regulator and hose assembly must be inspected before each use of the grill. If there is excessive abrasion or wear or if the hose is cut, it must be replaced prior to the grill being used again. ·Cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area. ·Never fill the cylinder beyond 80% full ·Do not store a spare LP-gas cylinder under or near this appliance 10 Leak Testing General Information Although all gas connections on the grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected. Before Testing Do Not smoke while leak testing. Mix a solution of equal parts mild detergent or liquid soap and water. 6. Note: If you cannot stop a gas leak turn off the gas supply and call your local gas utility, or the dealer you purchased the appliance from. If necessary, replace the faulty part with a manufacture recommended replacement part. Turn off the burner control knobs. Turn the top knob of the fuel supply cylinder counterclockwise (right to left) one rotation to open. Apply the soap solution to connections of the fuel supply assembly. If no soap bubbles appear, the grill is ok to use. If bubbles form at the connections, a leak is detected. (If a leak is detected, immediately turn off the gas supply, tighten any leaking fittings, turn gas on, and recheck). Turn off the knob on the fuel supply cylinder. Turn on the burner control knobs for a moment to release the pressure in the hose, then turn the control knobs back off. Wash off soapy solution with cold water and towel dry. Check all gas supply fittings before each use and each time the gas supply cylinder is connected to the regulator. Leak test any time a part of the gas system is replaced. Perform a leak test at least once a year whether or not the L. P. gas supply cylinder has been disconnected. 11 Using the Grill Grill Location Do not use the grill in garages, breezeway, sheds or any enclosed area. [. . . ] Push ignitor button, and check for spark on tip of electrode. Check to see if debris is blocking the electrode sparks. Attempt to match light the burner. If using L. P. gas, disconnect gas line at tank, then reconnect. [. . . ]