User manual AEG-ELECTROLUX GLGQ442CES

[. . . ] P/N 134447700 (0407) For your safety, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - WHAT TO DO IF YOU SMELL GAS: · Do not try to light any appliance. · Do not touch any electrical switch; do not use any phone in your building. [. . . ] Start the dryer. · · Push Start button for 2 seconds. To add or remove items when the dryer is running, open the door. The dryer will always stop when the door is opened. Allow the drum to come to a complete stop before reaching inside. To restart dryer, close the door, then push the START button for 2 seconds. The dryer will not start if the cycle selector is in the OFF position. · · Fill dryer drum 1/3 to 1/2 full. 7. When the cycle ends, remove items immediately and hang or fold. If load is removed before the cycle ends, turn cycle selector to OFF. 4 Features Features Cycle Signal Control (some models) When the Cycle Signal Control is ON, a signal will sound at the end of each cycle and during the Press Saver setting (some models). The volume is adjustable on some models. Drum Light (some models) A drum light will come on whenever the door is opened to illuminate the dryer drum during loading and unloading. Closing the door turns off the light. Reversible Dryer Door Your dryer is equipped with a reversible door. The door can be hinged on the right or left side. Refer to the INSTALLATION INSTRUCTIONS for directions on changing the door. Drying Rack (some models) Use the drying rack to dry items which should not be tumble dried. Open the dryer door and remove the lint screen. Place the front bar under the lip of the lint screen opening. Place items to be dried on top of the rack. Leave space between items, but do not let items hang over the sides or through the grids. Do not tumble other items when using the drying rack. Select a timed dry setting best suited for items being dried. Use only the Air Fluff (no heat) temperature setting for items containing plastic, foam rubber, rubberlike materials, feathers or down. When items are dry, remove the rack and replace the lint screen. If lint screen is not in place, tumbling items could enter the exhaust system and cause damage to the dryer. Place the front bar under the lip of the lint screen opening. Drying Problems Common Drying Problems Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association. PROBLEM POSSIBLE CAUSES Greasy, oily stains · Fabric softener sheet. SOLUTIONS · Rub fabric softener stains with bar soap. [. . . ] and Puerto Rico. 8 Service Information (Canada) To avoid unnecessary cost and inconvenience, make a few simple checks before calling for service. Common occurrences and their solutions can be found in the Avoid Service Checklist. Be sure you have followed the instructions in this manual. If you are unable to locate the cause of a problem, call for service. [. . . ]