User manual AEG-ELECTROLUX HC3360M

[. . . ] DK DK DK DK HC 9160-9190 9360-9390 9660-9690 9960-9990 5690-3360 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press once or more to obtain the function desired: Stand-by (illuminated push button): the hood is ready to function, the safety procedure is activated (see under safety procedure). OFF: all the functions are switched off except the illumination. Speed selection push button (extraction power). Press this push button once or more to select the most suitable extraction speed (power) (1-2-3-i). Attention: the i (intensive) speed is limited to 5 minutes after which the system automatically sets itself to speed 2. The display indicates the selected extraction power (1-2-3-i) and signals the saturation of the filters (F). Manual function selection push button (OFF)/automatic (sensors ON). In automatic function (ON) the hood enters into function (extraction) on the basis of the change in the normal environmental conditions that the hood notices through its sensors. The display shows the extraction speed (power) set. The hood is equipped with an automatic system that establishes what the normal environmental conditions are. C D E 68 In the case of abnormal operation, calibration can be carried out manually: Manual calibration Carry out manual calibration in the following cases: When the hood is installed for the first time. When power is cut off for many hours or days (e. g. When a very rapid change in temperature and/or humidity in the kitchen takes place. Carry out calibration with the hob off, at normal ambient temperature and in the absence of an appreciable amount of steam: press push button A and set the hood OFF (A key OFF) press push buttons A and D simultaneously for 3 secs. The hood emits a sound signal to indicate calibration taking place. Sensors test When functioning in automatic, the system continuously tests the efficiency of the sensors. In case of damage, it signals the fault, making the D push button flash the word SENSOR. In this situation the hood can, in any case, be used in the manual mode. Safety procedure Self-activation of automatic SAFETY functioning in particular conditions: if the sensors reveal an excessive increase in temperature, even if the hood is in manual functioning mode, the system self selects automatic functioning and the extraction motor starts. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. [. . . ] 75 Technical Details Models Dimensions - (in cm) Height Width Depth Maximum absorbed power Motor power Lighting Length Electrical of the cable connection DK 9160 80-135 59, 8 DK 9190 82-137 89, 8 DK 9360 80-135 59, 8 HC 3360 DK 9390 82-137 89, 8 DK 9660 80-135 59, 8 HC5690 DK 9690 82-137 89, 8 DK 9960 80-135 59, 8 DK 9990 82-137 89, 8 47 48 47 48 47 48 47 48 170 W 170 W 200 W 200 W 290 W 290 W 290 W 290 W 1 x 170W 1x11W (PL) 1 x 170W 1x11W (PL) 1 x 170W 2x20W (G4) 1 x 170W 2x20W (G4) 1 x 250W 2x20 W (G4) 1 x 250W 2x20 W (G4) 1 x 250W 2x20 W (G4) 1 x 250W 2x20 W (G4) 180 cm 180 cm 150 cm 150 cm 150 cm 150 cm 150 cm 150 cm 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V Mounting accessories included 6 wall plugs Ø 8 mm (brick fixing only) 6 wood-screws 5 x 45 mm 2 metal screws 2, 9 x 13 4 metal screws 2, 9 x 6, 5 5 metal screws 3, 5 x 9, 5 2 hooks 1 chimney support 2 clamps 1 deflector 1 reduction flange Ø 150-125 mm 1 charcoal filter frame 1 allen spanner 1 tube (DK 9960- DK 9990) 76 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. [. . . ]