User manual AEG-ELECTROLUX HC8830EN

[. . . ] TOOLS AND MATERIALS REQUIRED (continued) For Ductfree Installations Only: t One two-pack HF88 Replacement Filter Kit For Installation On Kitchen Cabinets With Recessed Bottoms Only: t Two 1" x 2" x 12" (approximate length) wood strips (purchase locally) t Four 1-1/4" long flat head wood screws (purchase locally) to fasten strips to cabinet bottom PLAN DUCTWORK INSTALLATION (continued) FIG. 1C ROOF CAP 3-1/4" X 10" DUCT PLAN DUCTWORK INSTALLATION For Ducted Installations Only: Begin planning ductwork by deciding where duct will run between hood and outside. For best performance, use shortest possible duct run and a minimum number of elbows. In more complex situations, 3-1/4" x 10" duct can be converted to round duct by means of a transition. [. . . ] Fasten wall cap to last section of duct and nail or screw cap to wall. Seal all around flange on wall cap with caulking compound. Make sure that enough duct runs into the room so that the duct will overlap the damper/duct connector by 3/4" when the hood is installed. a. ) electrical wiring runs through opening in top or back of hood. b. ) large part of keyhole slots fit over hood mounting screws For Ducted Installations Only: c. ) damper/duct connector slides into ductwork. Push hood back so that mounting screws slide into narrow end of keyhole slots. When mounting larger hoods, run (2) screws through the 1/4" dia. holes (in hood top and 8" each side of center) and into the cabinet bottom or added filler strips. Install locknut on electrical connector and tighten securely. Connect white to white, black to black, and green or bare wire to green ground screw. 7B 3/4" BLACK K AC BL PLASTIC ROOF CEMENT WH ITE WH ITE FIG. 7D NAIL BLACK WHITE GREEN GREEN GROUND (BARE OR GREEN WIRE) CK BLA DO NOT CAULK AROUND BOTTOM OF FLANGE FOR DRAINAGE ROOF CAPS (FIGS. 7A - 7D) Cut hole in roof slightly larger than duct so duct will line up easily with hood. Trim shingles around hole so that they will fit snugly around hood of cap when cap is installed. Assemble the ductwork and tape all joints. Trim duct parallel to roof pitch, leaving 3/4" of duct projecting above roof (FIG. (FIG 7B) Install roof cap, inserting back edge of cap under shingles. (FIG 7C) Seal around roof cap with roof cement and seal all nail heads and shingles which were cut or lifted. 7D) Make sure that enough duct runs into the room so that the duct will overlap the damper/duct connector by 3/4" when the hood is put into place. 5. Make sure that wires are not pinched between cover and hood. bulbs, or one 75 watt bulb and one 25 watt bulb for night-light use. Install 25 watt bulb in righthand socket. 5 WH ITE INSTALL HOOD (Continued) For Ducted Installations Only: FIG. 10 BLOWER DISCHARGE INSTALL HOOD (Continued) For Ductfree Installations Only: 9. [. . . ] · Smother flames with a close fitting lid, cookie sheet or metal tray. · Flaming grease can also be extinguished with baking soda or a multi-purpose dry chemical extinguisher. · Turn off surface units - If you can do so without getting burned. BLOWER - "SPEED" Infinite speed slide control adjusts blower speed and sound level for quiet operation BLOWER - "ON" Turns blower ON and OFF. When this control is turned ON, blower will operate at preset speed of slide control. [. . . ]