User manual AEG-ELECTROLUX HD 8760

[. . . ] The premises must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The suctioned air must not be conveyed into a conduit used for the disposal of the fumes generated by appliances that combust gases or other fuels. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and burst into flames. [. . . ] Every time the cooker hood is used, check whether the L2 LED is lit. The LED lights up in orange when the carbon filter needs to be cleaned/replaced; this happens approximately every 160 hours of operation. Every time the cooker hood is used, check whether the L2 LED is lit. After cleaning or replacing the filters, switch on the cooker hood at any suction speed (power), then press and hold the knob for more than 3 seconds, until you hear a beep indicating that the reset procedure has been performed successfully. the L2 LED and the cooker hood both switch off. In some situations (for example, when the L2 LED is indicating that the grease filters and the carbon filter are saturated), the procedure described above must be repeated. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Clean the outside of the hood using a damp cloth and a solution of mild washing up liquid and washing up liquid. Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal recycling function. Attention: the metal grease Extract filters must be removed and washed, either by hand or in the dishwasher, every four weeks. To access the grease filter, first remove the front panels which conceal the grease filter. Repeat the operation for all the small panels. Pull the handle downards, then extract the filter. Hand washing Soak grease filter(s) for about one hour in hot water with a Fig. 5 grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. [. . . ] Hang the hood (4) adjust its position (5-6) and from the inside of the hood sign two points for definitive fixing (7), remove the hood and drill two holes Ø 8mm (8), fit two wall plugs, hang the hood again and fix it securely with two screws (9). Cover the drill holes for screws with the two screw caps provided. Block the sides sliding the two tabs outwards 10a (11). Make electrical connection (12), but leave the hood 10b disconnected from the Fig. [. . . ]