User manual AEG-ELECTROLUX HD309000855EN

[. . . ] OWNER'S GUIDE READ AND SAVE THESE INSTRUCTIONS HEAVY DUTY AIR CONDITIONER VARIABLE SPEED ELECTRONIC CONTROL P/N 309000855 (11/03) ROOM AIR CONDITIONER WARRANTY Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this warranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer. WARRANTY PERIOD FULL ONE-YEAR WARRANTY FRIGIDAIRE, THROUGH ITS AUTHORIZED SERVICERS, WILL: THE CONSUMER WILL BE RESPONSIBLE FOR: One year from original Pay all costs for repairing or replacing parts of this Costs of service calls that are listed under NORpurchase date. [. . . ] · Operate heat producing appliances such as ranges, washers, dryers and dishwashers during the coolest part of the day. 4 Using Air Conditioner To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. To begin operating the air conditioner, follow these steps: 1. (To prevent electrical hazards, do not use an extension cord or an adapter plug. ) 2. Set the exhaust vent to the CLOSED position. Press "On/Off" button to turn unit on. Press "TEMP/TIME" up or down V to the desired set temperature. Review the "Air Conditioner Features" section for other settings. V Key Features (on some models) Precision-Temp: Remote Thermostat: The remote control serves as a remote thermostat allowing for the precise temperature control at its location. The Remote Sensing button on the remote control activates this feature. Precision-Aire: 90 Distinct fan settings give the ultimate in airflow and sound control. Clean-Aire: An ionic air filtration system that substantially increases the air-cleaning efficiency over conventional air filters. The Clean-Aire button on the air conditioner Touch Pad activates this feature. Air Conditioner Features ON/OFF LIGHT ELECTRONIC CONTROL OPERATING INSTRUCTIONS Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote. CLEAN AIR FEATURE (some models) DISPLAYS TEMPERATURE/TIME FAN SPEED ADJUSTS TEMP & TIMES FAN SPEEDS SETS MODES RENOTE SENSING (on some models ADJUSTS TEMPERATURE OR TIME SETS FAN SPEEDS TURNS UNIT ON OR OFF TIMER SETS MODE REMOTE CONTROL 5 Air Conditioner Features (continued) TO TURN UNIT ON: YOU WILL SEE: DO THIS: PRESS ON/OFF BUTTON TO CHANGE TEMPERATURE SETTING: YOU WILL SEE: DO THIS: PRESS TO RAISE PRESS TO LOWER Note: Tap or hold either up(^) or down(v) button until the desired temperature is seen on the display. This temperature will be automatically maintained anywhere between 60 F (16 C) and 90 F (32 C). If you want the display to read the actual room temperature, see "Operate in Fan Only. " O O O O TO ADJUST FAN SPEEDS: YOU WILL SEE (10-99): DO THIS: PRESS TO SELECT: FASTER SLOWER A 2 Digit Display is used to indicate the Fan Speed setting, from 10 through 99. When the "SLOWER" button is pressed the motor speed will slow down at various intervals, down to a minimum setting of 10. To speed the motor up, press the "FASTER" button. The speed will increase at various intervals to a maximum setting of 99. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. PRESSING The on/off button, at anytime, will cancel the delay function. LIGHT ON SLEEP FEATURE: YOU WILL SEE: DO THIS: PRESS SLEEP BUTTON Note: In this "MODE" the set temperature will increase by 2 degrees F, 30 minutes after the mode is selected. The temperature will then increase by another 2 degrees F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected temperature. [. . . ] Replace fuse with time delay type or reset circuit breaker. Turn Control ON and set to desired FAN or COOL setting. Unit turned off and then on too quickly. Wait 3 minutes for controls to automatically reset. Air from unit does not feel cold enough. Room temperature below 60°F (16°C). [. . . ]