User manual AEG-ELECTROLUX HD6470-M

[. . . ] DM 8700 - DM 8600 DM 8400 - DD 8770 HD 6470 Dunstabzugshaube Afzuigkap Hotte aspirante Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Contents Safety warnings For the user For the installer Description of the appliance Extraction Recirculation Control Panel - Model DM 8700 - DD 8770 Switching on the hood Switching on the light Control device for grease or charcoal filter Led signal for grease filter Led signal for charcoal filter Re-setting the saturation signal Control Panel - Model DM 8600 Control device for grease and charcoal filters Grease filter LED (D) Charcoal filter LED (E) Resetting the saturation indicator Control Panel - Model DM 8400 - HD 6470 Maintenance and care Cleaning the hood Metal grease filter Removing the metal grease filter Charcoal filter Changing the light bulb Special accessories What to do if Technical assistance service Technical specifications Mounting accessories included Electrical connection Safety warnings for the electrician Wall unit mounting Special accessories/Vapour screen 65 65 66 68 68 68 69 70 70 70 70 70 70 71 72 72 72 72 73 74 74 74 74 75 76 76 77 78 79 79 80 80 81 84 64 Safety warnings For the user The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. [. . . ] The control switches are located on the hoods front panel: A B C D E Mains switch, OFF. Start and choice of motor speed 1-2-3 Indicates speed 1 (LED). Indicates speed 2 and saturation of the grease filter (LED) Indicates speed 3 and saturation of the charcoal filter (LED) (flashing LED) Indicates Intensive speed (LED). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. Light OFF Light ON FG- HI- A B CDE F G H I Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. 71 Grease and charcoal filter maintenance indicator This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Press buttons B and G simultaneously and hold them for 3 seconds. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Fig. 4 Removing the metal grease filter Pull the handle downwards, then remove the filter. Hand washing Soak grease filters for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). 74 Charcoal filter The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. With normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, on average). [. . . ] Assembling the chimney flue support/bracket (3 parts): The three parts should be fixed with 4 screws, the support extension is adjustable and should correspond to the internal width of the telescopic chimney flue. Assembling the deflector (3 parts only for filter version): The three parts should be fixed with 2 screws, the deflector extension is adjustable and should correspond to the width of the chimney flue support, to which it is then fixed. = B 180° X G = = X = X F A C - OK! H F G Fig. 8 Only for DD 8770 and HD 6470: Assemble the frame to the motor group (a - Fig. Connect lamps and control panel to the motor housing (b - Fig. [. . . ]