User manual AEG-ELECTROLUX HD8510-M

[. . . ] CHDD 8509 CHDD 8510 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Campana extractora Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Instrucciones de montaje y manejo Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] - the length should be no more than: 3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90° will reduce the efficiency of the hood and reduce the airflow. Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood. 50 Description of the Appliance The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The cooker hood is supplied ready for use as a recirculation hood and may be used for extraction by removing the charcoal filter which has been fitted inside the cooker hood. Extraction mode In this mode fumes are extracted to the outside via a hose connected to the coupling ring A. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. A Fig. 1 Recirculation mode The air is filtered through a charcoal filter and returned to the kitchen. You will need an original charcoal filter for the recirculation mode. The deflector should be mounted on the wall near the ceiling with two wall dowels and 5x45 screws. Connect a tube to the exit hole of the hood (A-Figure 1) long enough to reach the deflector connection ring (B-Figure 2). B Fig. 2 51 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hoods front panel: Light switch: this switch is used to turn the light fitted in the hood on and off. Extractor fan switch: used to turn the fan off Push-button 1: used to set the fan to speed 1. Push-button 2: used to set the fan to speed 2. Push-button 3: used to set the fan to speed 3. Light switch Extractor fan switch Push button 1 Push button 2 Push button 3 52 Maintenance and Care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Never use corrosive, abrasive or flammable cleaning products or products containing bleach. Never insert pointed objects in the motors protective grid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Metal grease filter The purpose of the grease filters is to absorb grease particles which form Fig. 3 during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. [. . . ] If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The safety cut-out device has been tripped. Help us to help you Please determine your type of enquiry before writing or telephoning. [. . . ]