User manual AEG-ELECTROLUX HD8990

[. . . ] HD 8990 HD 8960 Cooker Hood Operating and Installation Instructions Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The hood is equipped with an automatic system that establishes what the normal environmental conditions are. In the case of abnormal operation, calibration can be carried out automatically or manually (see next page Automatic calibration and Manual calibration). Display Start and choice of motor speed 1-2-3-1-2. . . . . . . . . The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood will revert to previous speed after 5 minutes. 6 7- If the hood is off when the Intensive speed is activated, the hood will automatically turn off after 5 minutes. To interrupt the Intensive speed, press button 1 or 5. The letter P appears on the display and the remaining time (the point a is flashing), if interrupted an acoustic signal is heard. Self-Timer: times all the speed levels (the point b is flashing), and then the cooker hood switches off: The self-timer is set as follows: 1st speed level 20 minutes 2nd speed level 15 minutes 3rd speed level 10 minutes P (intensive) speed level: 5 minutes The display shows the remaining operation time, at the end of the time an acoustic signal is heard. Depressing the push-button again exits the function. Automatic Sensor calibration: The automatic calibration is carried on by the hood itself every 30 minutes. When the hood is installed for the first time or the power is cut off for many hours or days, please wait 30 minutes before the use or make a manual calibration. Manual Sensor calibration Carry out calibration with the hob off, at normal ambient room temperature and in the absence of an appreciable amount of steam: -press switch 3 for about 3secs , then press switch 1, the hood emits a sound signal to indicate calibration taking place. Sensors test When functioning in Automatic mode, the system continuously tests the efficiency of the sensors. In case of a fault the display shows 88. Contact your local Service Force Centre. . In this situation the hood can, in any case, be used in the manual mode. Safety procedure Self-activation of Automatic (SAFETY) mode: if the sensors reveal an excessive increase in temperature, even if the hood is in Manual mode, the system self selects the Automatic mode and the hood selects the necessary speed. The hood can be turned off by pressing push switch 1. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. 7 Grease and charcoal filter maintenance indicator This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Press button 1 to switch OFF. Press buttons 3 and 5 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will illuminate, but when the charcoal filter LED C illuminates the saturation indicator will be enabled. [. . . ] Help us to help you Please determine your type of enquiry before writing or telephoning. When you contact us we need to know: Your name Clear and concise details of the fault Address and post code Name and model of the appliance* Telephone number E number* Serial number* * This information can be found on the rating plate, which can be seen when the grease filters are removed. If you require Customer Service in the Republic of Ireland please contact us at the address below: AEG Electrolux Group (Ire) Ltd Long Mile Road Dublin 12 Republic of Ireland Tel: + 353 (0) 1 4090751 Email: service. eid@electrolux. ie CUSTOMER CARE DEPARTMENT For general enquiries concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www. aeg. co. uk Customer Care Department AEG 55-77 High Street Slough, Berkshire SL1 1DZ 08705 950950 (*) * calls to this number may be recorded for training purposes. 13 Technical Details Model Dimensions (in cm): Height Width Depth Maximum absorbed power: Motor absorption: Lighting: Length of the cable: HD 8990 72-114 90 45 215 W 175 W 2 x 20 W 150 cm HD 8960 72-114 60 45 215 W 175 W 2 x 20 W 150 cm Mounting accessories included 1 allen spanner (for TORX screws). [. . . ]