User manual AEG-ELECTROLUX HDINSTALLATION309000906

[. . . ] 2, or by removing storm window while room air conditioner is being installed. 1 BOARD THICKNESS AS REQUIRED, ALONG ENTIRE STOOL. FASTEN STORM WINDOW FRAME OR OTHER OBSTRUCTION WITH TWO NAILS OR SCREWS. STORM WINDOW FRAM E OR OTHER OBSTRUCTION 309000906(11/03) 1 4. CHECK FOR ANYTHING THAT COULD BLOCK AIRFLOW - check area outside of window for things such as shrubs, trees, or awnings. [. . . ] Assemlle sill angle bracket to support brackets at the marked position, as shown. Hand tighten, but allow for any changes later. Install support brackets (with sill angle brackets attached) to correct hole in bottom of cabinet as shown. Tighten all 6 bolts securely. Bottom Rail Seal 1/2''long screws and locknuts 3/4''LONG HEXHEAD SCREW 4 6 Extend Window Filler Panels 8 1. Carefully raise window to expose filler panel locking screws. Loosen screws so filler panels slide easily. Install Chassis into Cabinet and Install Front to Unit !Lift chassis and carefully slide it into installed cabinet. DO not push on controls OR finned coils. LOCKING SCREWS 3. Be sure chassis is firmly seated towards rear of cabinet. Refer to Owner's Guide for front installation. 2. Extend panels to fill window opening completely. Close window behind top angle. 7 Install Window Lock and Sash Seal 1. Insert into space between upper and lower sashes. WINDOW SASH SEAL 2. Attach right angle safety lock as shown. SAFETY LOCK 3/4''long hexhead screw 5 Thru-The-Wall Installation NOTE: Consult local building codes prior to installation, or a qualified carpenter. Carefully measure and cut an opening with t he following dimensions. WIDTH " = 26-3/4'' (67. 9cm) plus twice the thickness X" of framing material used. HEIGHT " = 18-7/8'' (47. 9cm) plus twice the Y" thickness of framing material used. 2 1 Select Wall Location This air conditioner has a slide-out chassis, so it can be installed through an outside wall up to 12'' thick. IMPORTANT: Side louvers must never be blocked. NOTE: All parts neede for Thru-The-Wall Installation are provided, except a wood frame, shims, and 10 wood screws (# 10-1'' long minimum). does not support major structural loads such as the frame construction at ends of windows, and under truss-bearing points, etc. does not have plumbing or wiring inside. [. . . ] Secure cabinet in place using masonry nails, or the right masonry anchor screws. (Another way to do this is to build an in-between frame of 2x4' as shown in the Step 2 Prepare s Wall illustrations-but make it double framed on either side, and install between masonry wall opening and cabinet. Frame must be securely anchored to masonry wall opening) This way gives very good louver clearance on either side of cabinet. Install a lintel to support masonry wall above cabinet. [. . . ]