User manual AEG-ELECTROLUX HG 755520 UM

[. . . ] FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler ­ features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you'll find everything you need to keep all your AEG appliances looking spotless and working perfectly. [. . . ] ⷠYou must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. To prevent the risk of physical injury or damage ­ Disconnect the appliance from the power supply. ­ Cut off the mains cable where it connects with the appliance and discard it. ⭠Flat the external gas pipes if there are fitted. ­ Speak to your local authorised facilities for disposal of your appliance. The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. It is necessary that the connection to the gas mains are carried out by means of an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel) in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. The connection must be done according to regulation NBN D 5I. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". All the components shown in the figure have already been assembled in the factory. The appliance, before leaving the factory, has been tested in order to give you the best results. If it is possible to easily control the connection in its full area, you can use a flexible pipe. The flexible pipe is prepared for apply when: ­ it can not get hot more than room temperature, higher than 30°C; ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. Installation ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section). Assemble the parts, follow the same procedure backwards. [. . . ] Clean the appliance with a damp cloth and some detergent. At the end rub the appliance dry with a clean cloth. In order to properly place the pan supports, make sure that the arms of the pan support are positioned in correspondence with the hole placed at the base of the burner. This way, the pan support will be stable and fixed. [. . . ]