User manual AEG-ELECTROLUX HK614000H

[. . . ] FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler ­ features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you'll find everything you need to keep all your AEG appliances looking spotless and working perfectly. [. . . ] ⷠDisconnect the appliance from the electrical supply, before you do maintenance work or clean. Make electrical mains terminal free of voltage. install correctly to give anti-shock protection. Loose and incorrect mains plug and socket connections can make the terminal become too hot. Use the correct mains connection cable and replace the damaged mains cable with proper special cable. The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 millimetres. ⷠIf the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket. ⷠYou must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. Manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these requirements. Ground the appliance according to safety precautions. ⷠMake sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. ⷠAny electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. Make sure that there is an access to the mains plug after installation. The appliance must not be connected with an extension cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. ⷠConnect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. Automatic line protecting cut-out, earth leakage trips or fuse. ⷠNone of a parts of the connection cable can not get a temperature 90°C. The blue neutral cable must be connected to the terminal block label with "N". The brown (or black) phase cable (fitted in the terminal block contact marked with "L") must always be connected to the live phase. Make sure that the cable section is applicable to the voltage and the working temperature. The yellow/ green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. [. . . ] Clean the appliance with a damp cloth and some detergent. Heat the hotplate to a low temperature and leave to dry. To maintain the hotplates, wipe the plates with a drop of olive oil on a kitchen towel to prevent rust. If the fuses ance does blow time after time, speak to an authorised electrician. [. . . ]