User manual AEG-ELECTROLUX HL4150-ML

[. . . ] DL 4150 - CHDL 4150 HL 4150 - DL 6250 570 D - 5708 D Cooker Hood Cappa aspirante Campana extractora Exaustor Operating and Installation Instructions Istruzioni di montaggio ed uso Instrucciones de montaje y manejo Manual de Instruções Contents Safety warnings For the user For the installer Description of the Appliance Extraction mode Recirculation mode Control Panel Maintenance and care Cleaning the hood Metal grease filter Removing the metal grease filter Charcoal filter Changing the light bulb What to do if Special accessories Technical assistance service Technical Specifications Electrical connection Installation Removing the hood from cabinet Relocating the control unit (Only 570 D - 5708 D) 3 3 4 6 6 6 7 8 8 8 8 10 11 12 13 13 14 15 16 18 19 2 Safety warnings For the user The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control. [. . . ] 570 D - 5708 D Fold the handles downwards and press them towards the centre. 4 8 DL 4150 - CHDL 4150 DL 6250 - HL 4150 Handle 570 D - 5708 D Hand washing Soak grease filters for about one hour in hot water with a little washing up liquid added, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 9 Charcoal filter The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original charcoal filter (available from your local Service Force Centre). Replacing the charcoal filter Type 150 Note: this filter is already installed on model 570 D-m9. This filter cannot be cleaned or reused. As a general rule, the activated charcoal filter should be changed once every 4 months. Cleaning/replacing the charcoal filter Type 150 LONG LIFE Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, on avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the charcoal, the filter should be dried in an oven for 10 minutes with a maximum temperature of 100ºC. After approximately three years of use, the charcoal filter should be replaced with a new, as the odour reduction capacity will be reduced. Fit the charcoal filter on the lamp side, press in both red lugs on the charcoal filter, and unclip the charcoal filter forwards (towards the front edge of the appliance). To remove proceed in the reverse order. Always specify the hood model code number and serial number when ordering replacement filters. [. . . ] Through the top of the wall unit, insert a pipe with a diameter of 120mm at the connection ring (3). Fit the connection ring on the hood exhaust outlet (4) and fasten it to the exhaust pipe. Insert the body of the hood into the hole in the base of the wall unit (5) check the position of the exhaust pipe and the electrical cable, press firmly so that the anchor springs (6) engage above the bottom of wall unit. Tighten the screws in the anchor springs firmly. [. . . ]