User manual AEG-ELECTROLUX HL7275-M-GB

[. . . ] 7 Charcoal filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Changing the light bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 What to do if . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Special accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] You will need an original charcoal filter for this function (Available from your local Service Force Centre). Hose* Cabinet Extraction In this version fumes are extracted to the outside via a hose connected to the coupling ring. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Coupling ring * The hose is not supplied and must be purchased separately. Fig. 1 Hose* Cabinet Recirculation Mode The air is filtered through a charcoal filter and returned to the kitchen. You will need an original charcoal filter for the filtering function. (See Special Accessories). Charcoal filters * The hose is not supplied and must be purchased separately. Fig. 2 5 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the units front panel. light switch motor switch Fig. 3 the light switch switches the hood lamp on and off the motor switch switches the motor on and off, enabling you to select one of the three different speeds. 6 Maintenance and care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. Only ever clean the switch panel and filter grill using a damp cloth and delicate detergents. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Metal grease filter The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal recycling function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Removing the metal grease filter Pull the handle downwards. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. 4 Place grease filters in the dishwasher. [. . . ] Remove the frame by pushing the two side release keys (5-6). Fix the coupling ring on the exhaust hole of the hood and make connection with the bottom end of the hose (7a-b), seal with tape. Attention: The hose is not supplied and must be purchased separately. Fit the hood into the opening and fix securely to the cabinet with 8 screws (9). [. . . ]