User manual AEG-ELECTROLUX IHGL90X

[. . . ] Ch 32 COOKER HOOD GENERAL The model you have selected is a decorative suction cooker hood which can also work as filtering hood. A SUCTION HOOD extracts air, fumes and vapours from the inside environment and then expels them outside. It is not necessary to use carbon filters for purifying. A FILTERING HOOD extracts air, fumes and vapours from the inside environment, purifies them by means of carbon filters and then emits the purified air into the same environment. [. . . ] Do not to cook "flambé" dishes, avoid flames directly underneath the hood; Avoid free flames underneath the hood; Avoid any strong flames being issued from under saucepans at the sides; when frying, do not allow oil to splash or overheat in the pan, as this is a fire risk; before any cleaning or maintenance operation, disconnect the hood from the main supply, by means of the main switch or the bipolar switch or by removing the plug; A contemporary use without danger of appliances connected to pipes (like fireplaces or gas equipment) with the hood is allowed only if the room or flat have a proper opening for 2 air arriving from the outside of circa 500/600 cm and if with the hood working a depression is avoided. For safe ventilation, maximum depression in the room should not exceed 4 Pa (0, 04 mbar). The air discharge must be brought outside by a separate pipe and cannot be connected to a scavenging pipe or chimney. Never use the hood without the grease filters; keep the grease filters clean, taking into account the recommended cleaning suggestions; replace or regenerate the carbon filters (if the hood is used as a filtering hood), at the intervals indicated; turn on the hood motor before you start cooking; · The cooker hood must be used only in private houses for domestic use and to aspirate vapours and fumes in the kitchen. 36 FUNCTIONS AND USE SL SERIE: LED ABOVE PUSH BUTTONS GL: BUTTONS WITH LIGHT ON THE BACK The led points above the push buttons are showing the 4 different speeds of the motor. The led points of the push buttons are showing the 4 different speeds of the motor. Short pressing: it switches the lights on and off. Long pressing: it changes the intensity of the light. It is normal to have a little whistle with middle intensity of the light. The highest speed is shown with the led flashing and after 10 minutes the motor goes automatically to speed 2. It stops the motor TIMER: with the first, second or third speed after 10 minutes it sets the automatic switch off of the motor and the Led point above the push button is flashing. REMOTE CONTROL first speed second speed third speed Highest speed: the point of the led is flashing and after 10 minutes the motor goes automatically to the second speed. It stops the motor TIMER: on the first, second or third speed it sets after 10 minutes the switching off of the motor and the point of the led is flashing. The functions of the controls can be activated also by a remote control. For the hoods of the GL serie it is possible to order the remote control as accessory The remote control is set up by the manufacturer. If the remote control is not controlling motor or light nearby the cooker hood, please do the following. Set up of the remote control: Keep pressing the push button of the remote control and the connect the cooker hood. to confirm that the remote control has been recognized a long beep is issued. If you do not hear the acoustic signal within 30 seconds, please repeat the steps as described. INTERVAL FUNCTION A specific function of this appliance is the Interval Function which consists in activating the motor in automatic way 10 minutes each hour at the flashing shown speed. 37 Interval function by controls (not possible for model WOSL90X): e , , . E e / / Keep pressing at the same time the push and : the led point of the first button speed will switch on, press again the push button , the light indicator will show the following for the speeds of the motor 23123 . [. . . ] Before replacing the lamps, make sure that they are cold and that power has been completely turned off. Follow the instructions phases as shown in Figures of the L SERIES. If the lights are not working kindly check tha the lamps have been inserted in a correct way. lED LAMPS To replace faulty Led Lamps always use an ELECTROLUX SERVICE CENTRE. [. . . ]