User manual AEG-ELECTROLUX IK257Z20LI

[. . . ] This information has been provided in the interests of your safety. Please read it before installing or using the appliance. Please retain the instruction book for future reference. If owner ship is transferred, please leave the user manual for the new owner. [. . . ] If the regulator is set at a higher level, wait about 4 hours before loading the appliance. During normal operation, it shows the temperature inside the refrigerator compartment. Caution: as many as 24 hours may be required before the temperature indicator shows the actual temperature. The SUPERCOOL function speeds up the cooling of fresh food products while at the same time protecting those already stored from undesirable heating. ⷠIt is possible to stop this function at any time by pressing the SUPERCOOL button once again. ⷠIf the SUPERCOOL function does not stop manually, it is automatically cut off electronically after about 6 hours. The shelves of the inner door can be removed to be moved or cleaned. The warmest zone is at the top, and the coldest zone is above the cover of the vegetable bins. How often the door is opened · amount of food products stored · Appliance setting The distance between shelves can be altered as one likes. To remove the shelves, lift from the bottom and pull forward until they move upwards or downwards and can be pulled out. Put the shelves back in the desired position. To freeze foods, turn on the SUPERFROST function 24 hours before freezing. Just 4-6 hours are needed for a lower quantity. Put the tray under running water in order to easily remove the ice cubes. Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. The defrost water drains out through a trough into a container at the back of the appliance, above the motor compressor, where it evaporates. Never use metal objects for cleaning your appliance as it may get damaged. NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour. Clean the inside with warm water and bicarbonate of soda. Complete defrosting should be carried out. Remove any stored food, wrap it in several layers Pull out the plug from the wall socket or turn the ther-mostat knob to the «O» setting. [. . . ] Temperature control may cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. The motor may cause a humming noise and/or slight bumping. The insulation material used has a tendency to slighly increase noise levels, how ever it allows for much better insulation and a lower energy consumption. [. . . ]