User manual AEG-ELECTROLUX IK32110RE

[. . . ] Please ensure that the piping of your appliance is not damaged before it is transported to the proper environmentallyfriendly disposal facility. For disposal of your old appliance, please contact the appropriate facilities of your local authorities. (Unfasten the hinges and remove the doors so that children playing cannot lock themselves in and be in mortal danger). disposal of the packing material All packing materials used are environmentally compatible and recyclable. [. . . ] 5 seconds after releasing the button, the display stops flashing and the current average temperature is displayed again. An actual value averaged over 2 hours is displayed, which may be different from the set value. This can be the case particularly if the door has been open for a while or if a large amount of warm foodstuffs have just been stored. If the temperature is lower than -30°C, «LO» is displayed; if it is higher than -5 °C, «HI» is displayed. After 24 hours the system is reset to the original setting and the snowflake disappears. The fast freeze function can also be disabled before this time by pressing the button manually again. -14°C): After 3 seconds the temperature display starts to flash and shows the selected temperature value. Each time you now press the button, the temperature value is increased by 1°C. If you hold down the button, the value increases automatically until you release the button or the maximum value is reached. After 24 hours the system is reset to the original setting and the fan disappears. The fast cool function can also be disabled before this time by pressing the button manually again. The water flows out through a drain hole (Figure %) and evaporates in the collecting tray outside the device. Be sure to keep the collection channel and the drainage channel clean, so that the melted water can flow out easily. Clean out the drainage channel with the green cleaner provided using an up-and-down and turning motion. defrost the freezer compartment if the ice formation becomes excessive. A thick coating of ice reduces the effectiveness of the cold transfer to the frozen products. Keep the frozen products as cold as possible and well insulated during the defrosting time, e. ­ Turn off the appliance by using the main switch (3 sec. Defrosting can be accelerated significantly if you place a bowl of hot water in the freezer compartment. Attention: do not use sharp implements to remove ice or anything hard frozen. do not use an electrical heater or an open flame for defrosting. ­ After defrosting clean the interior and dry it thoroughly. [. . . ] : Please only use original LED lighting from the manufacturer. Condensation can form on the glass shelves if products are stored which emit water vapour. As the electronic control in the cold room only defrosts about once per day, the ice formation on the rear wall in the cold room itself can be more marked than is usual in previous refrigerators. Be careful that products do not come into contact with the rear wall of the cold room so that they do not freeze to it and that, during defrosting, water does not get diverted into the cold room. [. . . ]