User manual AEG-ELECTROLUX JKE4034

[. . . ] Never pull or lift the vacuum cleaner by the cord. all servicing and repairs must be performed by an authorized Electrolux service centre. Store the vacuum cleaner in a dry place. 23 24 Insert the hose until the catches click to engage (press the catches to release the hose). [. . . ] 11 English Getting the best results Use nozzles as follows: Carpets and hardfloors: For carpets use the combination floor nozzle* with lever in position (32a) For Hard floors, use the combination floor nozzle with lever in position (32b). Make sure the brushes on the nozzle are down to prevent scratching the floor surface. Reduce suction power for short pile small carpets. With the Dust Magnet* nozzle there is normally no need to switch mode (33a). Upholstered furniture and fabrics: Use the upholstery nozzle* (35) for sofas, curtains, lightweight fabrics etc. 32a 32b 33a 33b 34 Using the turbo nozzle* 37a/b Ideal for carpets and wall-to-wall carpeting to remove stubborn fluff and pet hairs. Note: Do not use the turbo nozzle on animal skin rugs or carpet fringes. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. 39 Open the lid of the dust container by sliding the open button on the right. 39 Öppna dammbehållarens lock genom att dra i öppningsknappen till höger. In such cases, disconnect the mains and allow to cool down for 20-30 minutes. Clear blockage and/or replace filters, empty the dust container and restart Tubes and hoses 51 Use a cleaning strip or similar to clear the tubes and hose. 52 Hose handle can be dismantled from hose if cleaning is needed. 53 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to the hose caused by cleaning it. Cleaning the floor nozzle 54 Be sure to frequently clean the combination floor nozzle. Remove dust-balls, hair or other objects that may be entangled. Larger objects can be accessed by removing the connection tube from the nozzle. Cleaning the turbo nozzle* 55 Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. Use the hose handle to clean the nozzle. [. . . ] If the cleaner still does not work, contact an authorized Electrolux service centre. Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorized Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. For any further problems, contact an authorized Electrolux service centre. [. . . ]