User manual AEG-ELECTROLUX K6.84

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. SAFETY INFORMATION INSTALLATION INSTRUCTIONS PRODUCT DESCRIPTION OPERATING INSTRUCTIONS On and Off Automatic Switch Off The heat setting Activation and deactivation of the outer rings Automatic Heat Up Using the Timer 42 43 46 47 47 47 48 48 48 49 STOP+GO Locking / unlocking the control panel The child safety device OffSound Control (Deactivation and activation of the sounds) HELPFUL HINTS AND TIPS CARE AND CLEANING WHAT TO DO IF. Subject to change without notice For your safety and correct operation of the appliance, read this manual carefully before installation and use. [. . . ] install correctly to give anti-shock protection. Loose and incorrect plug and socket connections can make the terminal become too hot. Use the correct mains cable of type H05BB-F Tmax 90°C (or higher) for a single-phase or two-phase connection. ⷠReplace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or higher). The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors. If you use a protection box (the additional accessory), the protective floor directly below the appliance is not necessary. Function starts and stops the hob shows the heat setting activates automatic heat-up starts and stops the outer ring starts and stops the outer ring Function selects the cooking zone shows the time in minutes shows for which zone you set the time starts and stops the key lock or child lock starts and stops STOP+GO OptiHeat Control (3 step Residual heat indicator) : continue cook / stay warm / residual heat. OptiHeat Control (3 step Residual heat indicator) Touch for 1 second to start or stop the appliance. You do not set the heat setting after you activate the appliance. ⷠYou spill something or put something on the control panel for more than 10 seconds, (a pan, a cloth, etc. ⷠStarting the CountUp Timer:touch of the timer comes on. When the indicator of the cooking zone flashes slower, the time counts up, display switches between and time elapsed (minutes) · Stopping the CountUp Timer: select the cooking zone with and touch or to switch off the timer. You can use the timer as a Minute Minder while cooking zones do not operate. When the time elapses, the sound operates and 00 flashes. When operates, you cannot change the heat setting. The heat setting that you set before comes on. it prevents an accidental change of the heat setting. The heat setting that you set before comes on. When you stop the appliance, you also stop this function. Starting the child safety device · start the hob with . Switching off the child safety device · start the hob with . [. . . ] ­ Remove after the appliance is sufficiently cool:limescale rings , water rings, fat stains, shiny metallic discolorations. Use a special cleaning agent for glass ceramic or stainless steel. Clean the appliance with a moist cloth and some detergent. At the end rub the appliance dry with a clean cloth. [. . . ]