User manual AEG-ELECTROLUX KAM300

[. . . ] Do not put water into the appliance when it is hot!Switch off the coffee maker and leave to cool for approx. Prior to carrying out maintenance or cleaning, ensure that the appliance is switched off and unplugged from the mains! Do not immerse the base unit in water! [. . . ] 0 Set the desired start time with the buttons H (Figure 2/E) and MIN (Figure 2/J). The start time must be set whilst the green lamp is flashing. If the green lamp has already ceased to flash before the settings are completed, press button AUTO (Figure 2/F) again and continue with the programming. This indicates that the settings are saved. At the start time, the green indicator (Figure 2/F) will go out and the red indicator next to the button (Figure 2/B) will be illuminated. Coffee using the coffee grinder You can prepare coffee with beans either immediately (, , Normal mode"), or by pre-programming the start time (, , Auto" function. For preparing coffee with beans you must set number of cups, coffee strength and where required the aroma setting. Number of cups Button 2-10 (Figure 2/G) is for setting how many cups are to be prepared. the grinder will grind the appropriate amount of coffee beans. The number of cups is indicated next to the symbol . Coffee strength Button (Figure 2/D) is for setting the coffee strength. After brewing the warming plate keeps the coffee in the glass jug warm. Two hours after brewing the appliance switches off automatically. As long as the red indicator next to button (Bild 2/B) is on, only the button will work. If, once pre-programmed, the start time, number of cups and coffee strength are not to be changed you need only press the AUTO button to activate the , , Auto" function. Preparing coffee in advance of your setting If the appliance is pre-programmed using the "Auto" function (the green indicator for the AUTO button is illuminated to indicate , , Auto" function activated), but you would like some coffee before the start time, then you must switch off the , , Auto" function with the button AUTO (Figure 2/F). Start coffee preparation in normal mode with the button (Figure 2/B). Cleaning (It is imperative that these instructions are observed!Place your finger in the rear handle recess (Figure 16) and pull the bracket up. This unlocks the filter insert and it can be removed for cleaning. activate the anti-drip valve several times during cleaning. After cleaning the filter insert, fit the swivel filter. [. . . ] If you are using a gold filter, remove it from the filter insert before descaling. Use only an environmentally friendly descaling agent and always follow the manufacturer's instructions. Do not use any descaler based on formic acid. Nor should you use a powder descaling agent. [. . . ]